82V2608BB IDT, Integrated Device Technology Inc, 82V2608BB Datasheet - Page 44

• Manufacturer Part Number: 82V2608BB
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of 82V2608BB

• Utopia Level: Level 2
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 2.97V
• Operating Supply Voltage (max): 3.63V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Package Type: BGA
• Pin Count: 208
• Mounting: Surface Mount
• Lead Free Status / Rohs Status: Not Compliant

Table-26 AddTxLink Command (Encoding: 0BH)
Command Parameters
IDT82V2608
PROGRAMMING INFORMATION for IMAOS08
Byte Sequence
1
2
3
4
5
6
7
Group ID
1
Tx link physical ID
Parameter Name
Tx link ICP offset
Tx link logical ID
Tx line interface
Tx line interface
Backup function
Work Mode
Group ID
Tx link physical ID
clock
2
Default
0FH
NA
NA
0H
0H
0H
NA
Tx line interface
Work Mode
3
The physical group ID (0~3).
This is the same Group ID in ConfigGroupPara command.
0~7
The Tx link that will be configured to this group. Data on TSD1 pin is deemed data on Tx link 0; Data on
TSD2 pin is deemed data on Tx link 1 and so on.
Note: If the value exceeds 7, IMAOS will work improperly.
Mode0~Mode15
Line interface Work Mode for this link.
Note: If the value exceeds 15, IMAOS will work improperly.
0: Common Clock Mode;
1: Independent Clock Mode
Line interface clock input mode. The line interface mode7~mode10 and mode14~mode15 cannot be
used in Independent Clock Mode.
Note: IMAOS does not check this value. Value exceeding 1 will cause wrong configuration.
0~31
The logical Tx link # designated to that physical link. It is used for Tx ICP cell.
Note: IMAOS does not check this value. If this value is wrong, IMAOS will work improperly.
The ICP offset over that Tx link
The ICP cell offset of the IMA frame on that link. This value should be smaller than the Tx frame length.
Note: If this value is wrong, IMAOS will work improperly.
0: No;
1: Yes
Whether this is a backup link or not. When other links failed, this link will be automatically added to the
group.
Note1: Only one backup link is supported in each group. If several links are specified as backup links,
only the last added backup link is regarded as a backup link.
Note2: If a backup link is added after the StartGroup or StartLASR command, a StartLASR command
should be issued to make this backup link take effect.
Tx line interface
clock
44
4
Tx link logical ID
5
Description
Tx link ICP offset
Inverse Multiplexing for ATM
6
December 4, 2006
Backup function
7