F3SJ-A0870P30 Omron, F3SJ-A0870P30 Datasheet - Page 4

• Manufacturer Part Number: F3SJ-A0870P30
• Description: F3SJ-A Safety Light Curtain, 30mm Resolution, 870 Mm Protected Height
• Manufacturer: Omron

Easier to install, easier to use.
The thin sensor saves valuable space.
The sensor is 6 mm thinner than our previous models.
When you include the newly designed mounting brackets, which also
enable beams to be aligned after the sensor is mounted, the total
thickness is 26 mm - a reduction of 19 mm compared to previous
models. The low profile means the sensor will not get in the way when
adding safety applications to existing equipment.
Flexible cable with a 5 mm bending radius makes
wiring a snap.
The F3SJ cables (0.3 m) have M12 connectors and can be routed in
any direction. Problems with connector compatibility have been
eliminated.
Previous
model
15 mm
Free-directional
cables can be
routed down,
back, left or right.
45 mm
30 mm
F3SJ
2 mm
26 mm
24 mm
Flexible cables
with 5 mm bending
radius can be
adhesively
mounted to the
floor.
The included standard mounting brackets are
easier than ever to use.
The included mounting brackets, which are suitable for general use,
have been redesigned with ease of use in mind.
The new design allows easy screwdriver access, even when
mounting in tight spaces. Also, after aligning the beams, screws can
be tightened while oriented perpendicular to the lens surface, just like
the panel mounting screws.
On previous models, the carefully adjusted beam angles would
sometimes come out of alignment when tightening the final screws.
This problem has been solved with the F3SJ, because the
screw-tightening direction is different from the angle adjustment
direction. The result is reduced installation time.
Side-mounting in tight spaces is simple.
When using standard mounting brackets to mount a sensor on its
side, the bracket protrudes outward in front of the lens surface. When
this protrusion is of concern, use the F39-LJ2 side-mounting brackets
(sold separately).
Easy to change from previous models.
When replacing your previous standard multiple-beam area sensor,
use the F39-LJ4 top / bottom mounting bracket B (sold separately),
which features enlarged mounting holes.
Previous model
6 mm
The direction of all screws
can be oriented
perpendicular to the lens
surface. Easy screwdriver
access.
Can be used with a pitch of 18 to 20 mm
F3SJ
10 mm
37 mm
The sensor can be rotated
along its axis. Beam
alignment can be fine-
tuned, even when mounted
side by side on a surface.
F3SJ Ver.2
4