F3SJ-A0870P30 Omron, F3SJ-A0870P30 Datasheet - Page 23

• Manufacturer Part Number: F3SJ-A0870P30
• Description: F3SJ-A Safety Light Curtain, 30mm Resolution, 870 Mm Protected Height
• Manufacturer: Omron

Connections
Basic Connection for Basic System
"Basic system" refers to the F3SJ with its default factory settings. The basic system provides basic safety light curtain functions.
Most functions can be used without performing additional configuration.
For PNP output (See page 24 for NPN output wiring.)
Wiring when using manual reset mode, external device monitoring
Wiring for auto reset mode
• The auto reset mode will be enabled when the emitter is
S1: External test switch (connect to 0 V if the switch is not
S3: Lockout reset switch (connect to 24 V if the switch is
K4: Load or PLC, etc. (for monitoring)
*1. Use a switch for micro loads (Input
*2. F3SJ operates even when K4 is not connected.
wired as shown below.
specifications: 24 V, 1.8 mA).
necessary.)
not necessary)
*2
K4
K4
*2
S1
S1
*1
*1
S2
S3
*1
*1
(Gray) Communication line (+)
Communication
Communication line (+) (Gray)
Communication line (−) (Pink)
line (−)
(Pink)
24 VDC
0 V
Power
supply
K1
K2
K3
*2
K1
(Gray) Communication line (+)
(Pink) Communication line (−)
Wiring when the external device monitoring function will not
be used
• Use a setting tool to set the external device monitoring function to
• When using an auxiliary output 1 that has not been changed (output
K2
"Disabled."
operation mode is "control output data," and inverse of control output
signals is "Enabled), the external device monitoring function will be
disabled when auxiliary output 1 and the external device monitoring input
are connected as shown below.
S1:
S2:
K1, K2: Relay or other device that controls hazardous parts of the machine
K3, K4: Load or PLC, etc. (for monitoring)
*1. Use a switch for micro loads (Input specifications: 24 V, 1.8 mA).
*2. F3SJ operates even when K3 and K4 are not connected.
K1, K2: Relay or other device that controls hazardous
K3:
* The F3SJ operates even when K3 is not connected.
When K3 is not necessary, connect auxiliary output 1
only to the external device monitoring input.
Load or PLC, etc. (for monitoring)
External test switch (connect to 0 V if the switch is not necessary.)
Interlock/lockout reset switch
parts of the machine
24 VDC
0 V
Power
supply
*
K3
K1
K2
F3SJ Ver.2
24 VDC
0 V
Power
supply
23