ISP1507EBS,518 NXP Semiconductors, ISP1507EBS,518 Datasheet - Page 28

• Manufacturer Part Number: ISP1507EBS,518
• Description: RF Transceiver USB 2.0 ULPI TRNSCVR
• Manufacturer: NXP Semiconductors

Specifications of ISP1507EBS,518

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant
• Other names: 935285498518 ISP1507EBS-T

NXP Semiconductors
ISP1507E_ISP1507F_1
Product data sheet
Fig 9.
USE_EXT_VBUS_IND,
RXCMD A_VBUS_VLD indicator source
IND_PASSTHRU
9.5.2.3 Using and selecting the V
IND_COMPL
V
BUS
/FAULT
The V
link whenever there is a change in the V
must first enable the corresponding interrupts in the USB_INTR_EN_R_E and
USB_INTR_EN_F_E registers.
The link can use the V
shows the recommended usage for typical applications.
Table 14.
Standard USB host controllers:
500 mA on V
detect overcurrent conditions. If the external overcurrent detector provides a digital fault
signal, then the fault signal must be connected to the ISP1507 FAULT input pin, and the
link must do the following:
Application
Standard host
Standard peripheral no
OTG A-device
OTG B-device
1. Set the IND_COMPL bit in the INTF_CTRL register (see
2. Set the USE_EXT_VBUS_IND bit in the OTG_CTRL register (see
3. Set the IND_PASSTHRU bit in the INTF_CTRL register to logic 1 (mandatory).
logic 1, depending on the polarity of the external fault signal.
logic 1.
BUS
state encoding is shown in
V
A_VBUS_VLD comparator
BUS
BUS
(V
indicators in RXCMD required for typical applications
BUS
in the range of 4.75 V to 5.25 V. An external circuit must be used to
< 4.4 V)
A_VBUS_VLD
yes
yes
no
BUS
Rev. 01 — 28 May 2008
internal A_VBUS_VLD
state to monitor V
BUS
state encoding
For standard hosts, the system must be able to provide
Table
BUS
SESS_VLD
no
yes
yes
yes
complement output
10. The ISP1507 will send an RXCMD to the
state. To receive V
BUS
ISP1507E; ISP1507F
and take appropriate action.
ULPI HS USB OTG transceiver
SESS_END
no
no
no
yes
(0, X)
(1, 1)
Section
BUS
state updates, the link
10.1.3) to logic 0 or
Section
© NXP B.V. 2008. All rights reserved.
RXCMD
A_VBUS_VLD
004aaa752
Table 14
10.1.4) to
27 of 78