LAN9303-ABZJ Standard Microsystem (Smsc), LAN9303-ABZJ Datasheet - Page 295

• Manufacturer Part Number: LAN9303-ABZJ
• Description: Ethernet Switch 3-Port 10Mbps/100Mbps 56-Pin QFN EP
• Manufacturer: Standard Microsystem (Smsc)

Specifications of LAN9303-ABZJ

• Package: 56QFN EP
• Phy/transceiver Interface: MII/RMII
• Number Of Primary Switch Ports: 3
• Maximum Data Rate: 100 Mbps
• Vlan Support: Yes
• Power Supply Type: Analog
• Minimum Single Supply Voltage: 3 V
• Maximum Single Supply Voltage: 3.6 V
• Maximum Supply Current: 0.19(Typ) A

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
SMSC LAN9303/LAN9303i
13.4.3.21
BITS
31:9
7:5
4:2
8
1
0
RESERVED
Enable RX Mirroring Filtered
When set, packets that would normally have been filtered are included in the
receive mirroring function and are sent only to the sniffer port. When
cleared, filtered packets are not mirrored.
Note:
Sniffer Port
These bits specify the sniffer port that transmits packets that are monitored.
Bits 7,6,5 correspond to switch ports 2,1,0 respectively.
Note:
Mirrored Port
These bits specify if a port is to be mirrored. Bits 4,3,2 correspond to switch
ports 2,1,0 respectively.
Note:
Enable RX Mirroring
This bit enables packets received on the mirrored ports to be also sent to
the sniffer port.
Enable TX Mirroring
This bit enables packets transmitted on the mirrored ports to be also sent to
the sniffer port.
Switch Engine Port Mirroring Register (SWE_PORT_MIRROR)
This register is used to configure port mirroring.
The Ingress Filtered Count Registers will still count these packets
as filtered and the
(SWE_IPR)
Only one port should be set as the sniffer.
Multiple ports can be set as mirrored.
Register #:
will still register a drop interrupt.
Switch Engine Interrupt Pending Register
1846h
DESCRIPTION
DATASHEET
295
Size:
32 bits
TYPE
R/W
R/W
R/W
R/W
R/W
RO
Revision 1.4 (07-07-10)
DEFAULT
00b
00b
0b
0b
0b
-