CJ1W-EIP21 Omron, CJ1W-EIP21 Datasheet - Page 415

• Manufacturer Part Number: CJ1W-EIP21
• Description: Ethernet I/P Module
• Manufacturer: Omron

Specifications of CJ1W-EIP21

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Response Codes
General Status Code
The General Status Code is stored in the response data after execution of the CMND instruction has been
completed.
CIP Message Communications
00
01
02
03
04
05
06
07
08
09
0A
0B
0C
0D
0E
0F
10
11
12
13
14
15
16
17
18
19
1A
1B
1C
General Status
Code (hex)
Success
Connection failure
Resource unavailable
Invalid parameter value See Status Code 20 hex, which is the preferred value to use for this condition.
Path segment error
Path destination
unknown
Partial transfer
Connection lost
Service not supported
Invalid attribute value
Attribute list error
Already in requested
mode/state
Object state conflict
Object already exists
Attribute not settable
Privilege violation
Device state conflict
Reply data too large
Fragmentation of a
primitive value
Not enough data
Attribute not supported The attribute specified in the request is not supported.
Too much data
Object does not exist
Service fragmentation
sequence not in
progress
No stored attribute data The attribute data of this object was not saved prior to the requested service.
Store operation failure
Routing failure (request
packet too large)
Routing failure
(response packet too
large)
Missing attribute list
entry data
Status Name
A request to modify a non-modifiable attribute was received.
Service was successfully performed by the object specified.
A connection related service failed along the connection path.
Resources needed for the object to perform the requested service were
unavailable.
The path segment identifier or the segment syntax was not understood by the
processing node. Path processing shall stop when a path segment error is
encountered.
The path is referencing an object class, instance or structure element that is
not known or is not contained in the processing node. Path processing shall
stop when a path destination unknown error is encountered.
Only part of the expected data was transferred.
The messaging connection was lost.
The requested service was not implemented or was not defined for this Object
Class/Instance.
Invalid attribute data detected.
An attribute in the Get_Attribute_List or Set_Attribute_List response has a
non-zero status.
The object is already in the mode/state being requested by the service.
The object cannot perform the requested service in its current mode/state.
The requested instance of object to be created already exists.
A permission/privilege check failed.
The device's current mode/state prohibits the execution of the requested ser-
vice.
The data to be transmitted in the response buffer is larger than the allocated
response buffer
The service specified an operation that is going to fragment a primitive data
value, i.e. half a REAL data type.
The service did not supply enough data to perform the specified operation.
The service supplied more data than was expected.
The object specified does not exist in the device.
The fragmentation sequence for this service is not currently active for this data.
The attribute data of this object was not saved due to a failure during the
attempt.
The service request packet was too large for transmission on a network in the
path to the destination. The routing device was forced to abort the service.
The service response packet was too large for transmission on a network in
the path from the destination. The routing device was forced to abort the ser-
vice.
The service did not supply an attribute in a list of attributes that was needed by
the service to perform the requested behavior.
Description of Status
Appendix D
387