CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 9

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

2 Electrical Interface and Connectors
This section describes the signals available on the module interface connectors.
There are four ways to connect to the OEM Serial Port Adapter:
Picture 4: J6 are available on the edge of the cB-
0901.
Picture 6: JST 6-pol connector, J8.
J8
•
•
Optional:
•
•
Via the PCB solder pads on the edge of the PCB, J6 (see Picture 4). See Section 5.4 for
more information.
Via the 2x20-pin 1mm pitch board-to-board (one piece part) connectors, J2 through J3.
The J2 to J3 connectors on the OEM Serial Port Adapter exist on the module only as a
mating PCB-layout pattern (see Picture 5). See Section 5.2 for more information.
Via the JST connector, J8 (see Picture 6). The connector is a 6 poles wire connector. The
pitch is 1mm and the. The connector is from JST with part number SM06B-SRSS-TB.
Via the flexfilm connector, J7 (see Picture 7). The connector is a 16 poles flexfilm con-
nector. The pitch is 0.5mm and the flexfilm should be 0.3mm thick. The connector is
from Hirose with part number FH19S-16S-0.5SH(05).
J6
Version 1.16 - 2009-12
Picture 5: J2 to J3 are available on cB-0901. Some
of the not used pads are not visible.
Picture 7: Flexfilm connector, J7.
J2
J7
J3
9