CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 42

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (EIRP) is not more than that required for
successful communication.
The installer of this radio equipment must ensure that the antenna is located or pointed such
that it does not emit RF field in excess of Health Canada limits for the general population; con-
sult Safety Code 6, obtainable from Health Canada’s website www.hc-sc.gc.ca/rpb.
7.3.1.3 Labeling Requirements for End Product
For an end product using the product cB-0901-0301 there must be a label containing, at least,
the following information:
The label must be affixed on an exterior surface of the end product such that it will be visible
upon inspection in compliance with the modular approval guidelines developed by the FCC.
In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a
conspicuous location on the device:
“This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.”
When the device is so small or for such use that it is not practicable to place the statement
above on it, the information shall be placed in a prominent location in the instruction manual or
pamphlet supplied to the user or, alternatively, shall be placed on the container in which the
device is marketed. However, the FCC ID label must be displayed on the device.
In case, where the final product will be installed in locations where the end-user
is not able to see the FCC ID and/or this statement, the FCC ID and the statement shall also be
included in the end-product manual.
This device contains
FCC ID: PVH090103S
IC: 5325A-090103S
Version 1.16 - 2009-12
42