CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 12

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

* All signals are logic level UART signals (typically 0 - 3VDC)
** Use 1kΩ as pull-down which is different to previous product generations from connectBlue
J2
Pin Nr
13
14
15
16
17
18
19
20
Pin Name
GREEN/
Switch-1
BLUE
UART-CTS*
UART-TxD*
UART-RTS*
UART-RxD*
UART-DTR*
UART-DSR*
Signal Name
Green LED output and
Restore switch
Blue LED output
Clear To Send
Transmit Data
Request To Send
Data Terminal Ready
Data Set Ready
Receive Data
Version 1.16 - 2009-12
CMOS
CMOS
CMOS
CMOS
Signal
Level
CMOS
CMOS
CMOS
CMOS
Type
In/Out
Out
In
Out
Out
In
Out
In
Description
This signal is multiplexed:
GREEN:
Logic Green LED Signal (see Chapter
3, Table 14). Not valid until 500ms
after startup. Active low.
Switch-1:
If the level on this pin is pulled-
down with 1kΩ** the units goes
back to default serial settings. The
module will restore all factory set-
tings if both the Switch-1 and
Switch-0 signals are low during start
up.
The “Restore Default” input is only
active during the first 500ms after
startup.
See the Serial Port Adapter AT
command Specification for more
information on the Restore switch.
See section A.2.3.2 for design ex-
amples.
Logic Blue LED Signal (see Chapter
3, Table 14). Active low.
Note:
Signal will flicker at data transmis-
sion.
See section A.2.3.1 for design ex-
amples.
Hardware flow control.
Active low.
“0” : Low, “1” : High
Hardware flow control.
Active low.
“0” : Low, “1” : High
Active low.
Active low.
Also used to control the power
saving mode “stop mode”.
See section 2.5 for more informa-
tion.
12