CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 48

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

Appendix A -
Usually only a subset of the available functionality is of interest to the designer. In addition, de-
pending on the host system, the electrical interface can be designed in many ways. The designer
can use the step-by-step guide in this chapter as an aid in the design process.
A.1 Step-by-Step Guide
Table 20: Step-by-step guide with Yes and No answers.
Question
Are you going to integrate the OEM
Serial Port Adapter in a metal enclo-
sure?
Do you wish to use logic level when
communicating with the OEM Serial
Port Adapter?
Do you want to use RS232 as the
physical serial interface?
Do you want to use RS485 or RS422
as the physical serial interface?
Is low power consumption important? The power consumption can be
Do you wish to connect LEDs to the
OEM Serial Port Adapter?
Do you want to detect the status of
the module with a controller?
Do you wish to utilize the restore
switch?
Do you wish to utilize the Function
switch (“Connect on external signal”)?
Do you want to manually reset the
module?
Version 1.16 - 2009-12
Yes
The internal antenna models can-
not be used. Use the OEMSPA311x
or OEMSPA331x.
See section A.2.2.1 for electrical
design.
See section A.2.2.2 for electrical
design.
See section A.2.2.3 - A.2.2.4 for
electrical design.
reduced by enabling the stop
mode, see Table 10. The stop
mode is controlled with the DSR
pin, see section 2.5. The power
consumption is optimized with
3.2-3.3 V supply voltage.
See section A.2.3 for design exam-
ples for connecting the LEDs.
See Chapter 3, Table 14 for status
detection and section A.2.3 for
electrical design.
See section A.2.3.2 for electrical
design.
See section A.2.3.4 for electrical
design.
See section A.2.4 for electrical
design. Use a double row connec-
tor. See section 5.2.1.2.
Application Notes
No
You are free to choose
between the products. The
internal antenna models are
lower cost and are easier to
design-in. However, an
external antenna could give
better range.
See section A.2.2.2 -
A.2.2.3 for electrical de-
sign.
Go on to next point.
Go on to next point.
Go on to next point.
Go on to next point.
Go on to next point.
Go on to next point.
Go on to next point.
48