CB-ACC-53 ConnectBlue, CB-ACC-53 Datasheet - Page 46

• Manufacturer Part Number: CB-ACC-53
• Description: ANTENNA DUAL-BAND RPSMA
• Manufacturer: ConnectBlue

Specifications of CB-ACC-53

• Antenna Type: Whip: 1/2 Wave, Swivel, Tilt (Right Angle)
• Number Of Bands: 2
• Frequency: 2.4GHz, 5GHz
• Gain: 3dBi
• Termination: RP-SMA
• Mounting Type: Connector
• Height (max): 4.21" (107mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 809-1035

8 Guidelines for Efficient and Safe Use
8.1 General
Read this information before using your OEM Serial Port Adapter.
For any exceptions, due to national requirements or limitations, when using your OEM Serial
Port Adapter, please visit www.bluetooth.org.
Note: Changes or modifications to the product not expressly approved by
connectBlue AB will void the user’s authority to operate the equipment.
8.2 Product Care
8.3 Radio Frequency Exposure
The OEM Serial Port Adapter contains a small radio transmitter and receiver. During communi-
cation with other Bluetooth products the OEM Serial Port Adapter receives and transmits radio
frequency (RF) electromagnetic fields (microwaves) in the frequency range 2400 to 2500 MHz.
The output power of the radio transmitter is very low.
When using the OEM Serial Port Adapter, you will be exposed to some of the transmitted RF
energy. This exposure is well below the prescribed limits in all national and international RF
safety standards and regulations.
• Do not expose your product to liquid or moisture.
• Do not expose you product to extreme hot or cold temperature (see Section 2.3.3 for fur-
• Do not expose your product to lit candles, cigarettes, cigars, open flames, etc.
• Do not drop, throw or try to bend your product since rough treatment could damage your
• Do not attempt to disassemble your product. Doing so will void warranty. The product
• Do not paint your product as the paint could prevent normal use.
• If you will not be using your product for a while, store it in a place that is dry, free from
• The clearance and creepage distances required by the end product must be withheld when
• The cooling of the end product shall not negatively be influenced by the installation of the
ther information).
product.
does not contain consumer serviceable or replaceable components. Service should only be
performed by connectBlue AB.
damp, dust and extreme heat and cold.
the module is installed.
module when the module is installed.
Version 1.16 - 2009-12
46