LPC1766-STK Olimex Ltd., LPC1766-STK Datasheet - Page 4

• Manufacturer Part Number: LPC1766-STK
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC1766 256KB FLASH 64KB RAM
• Manufacturer: Olimex Ltd.

Specifications of LPC1766-STK

• Processor To Be Evaluated: LPC1766
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet, USB, CAN, I2C, SPI, UART
• Dimensions: 134.6 mm x 101.6 mm
• Operating Supply Voltage: 3.3 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Split APB bus allows high throughput with few stalls between the CPU and
DMA.
Serial interfaces:
Other peripherals:
Ethernet MAC with RMII interface and dedicated DMA controller.
USB 2.0 full-speed device/Host/OTG controller with dedicated DMA
controller and on-chip PHY for device, Host, and OTG functions.
Four UARTs with fractional baud rate generation, internal FIFO, DMA
support, and RS-485 support. One UART has modem control I/O, and
one UART has IrDA support.
CAN 2.0B controller with two channels.
SPI controller with synchronous, serial, full duplex communication
and programmable data length.
Two SSP controllers with FIFO and multi-protocol capabilities. The
SSP interfaces can be used with the GPDMA controller.
Two I2C-bus interfaces supporting fast mode with a data rate of 400
kbits/s with multiple address recognition and monitor mode.
One I2C-bus interface supporting full I2C-bus specification and fast
mode plus with a data rate of 1 Mbit/s with multiple address
recognition and monitor mode.
I2S (Inter-IC Sound) interface for digital audio input or output, with
fractional rate control. The I2S-bus interface can be used with the
GPDMA. The I2S-bus interface supports 3-wire and 4-wire data
transmit and receive as well as master clock input/output.
70 General Purpose I/O (GPIO) pins with configurable pull-up/down
resistors and a new, configurable open-drain operating mode.
12-bit Analog-to-Digital Converter (ADC) with input multiplexing
among eight pins, conversion rates up to 1 MHz, and multiple result
registers. The 12-bit ADC can be used with the GPDMA controller.
10-bit Digital-to-Analog Converter (DAC) with dedicated conversion
timer and DMA support.
Four general purpose timers/counters, with a total of eight capture
inputs and ten compare outputs. Each timer block has an external
count input and DMA support.
One motor control PWM with support for three-phase motor control.
Quadrature encoder interface that can monitor one external
quadrature encoder.
One standard PWM/timer block with external count input.
RTC with a separate power domain and dedicated RTC oscillator. The
RTC block includes 64 bytes of battery-powered backup registers.
Watchdog Timer (WDT) resets the microcontroller within a reasonable
amount of time if it enters an erroneous state.
System tick timer, including an external clock input option.
Page 4