DF2367VTE33 Renesas Electronics America, DF2367VTE33 Datasheet - Page 656

• Manufacturer Part Number: DF2367VTE33
• Description: IC H8S MCU FLASH 384K 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2367VTE33

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2367VTE33; HD64F2367VTE33

Section 14 Serial Communication Interface (SCI, IrDA)
14.6.2
Before transmitting and receiving data, you should first clear the TE and RE bits in SCR to 0, then
initialize the SCI as described in a sample flowchart in figure 14.15. Do not write to SMR, SCMR,
IrCR, or SEMR while the SCI is operating. This also applies to writing the same data as the
current register contents. When the operating mode, transfer format, etc., is changed, the TE and
RE bits must be cleared to 0 before making the change. When the TE bit is cleared to 0, the
TDRE flag is set to 1. Note that clearing the RE bit to 0 does not change the contents of the
RDRF, PER, FER, and ORER flags, or the contents of RDR.
Rev.6.00 Mar. 18, 2009 Page 596 of 980
REJ09B0050-0600
Note: In simultaneous transmit and receive operations, the TE and RE bits should
Set TE and RE bits in SCR to 1, and
set RIE, TIE, TEIE, and MPIE bits
Clear TE and RE bits in SCR to 0
Set CKE1 and CKE0 bits in SCR
SCI Initialization (Clocked Synchronous Mode)
Set data transfer format in
both be cleared to 0 or set to 1 simultaneously.
1-bit interval elapsed?
Start of initialization
Set value in BRR
SMR and SCMR
<Transfer start>
(TE, RE bits 0)
Figure 14.15 Sample SCI Initialization Flowchart
Yes
Wait
No
[4]
[2]
[3]
[1]
[1] Set the clock selection in SCR. Be sure
[2] Set the data transfer format in SMR
[3] Write a value corresponding to the bit
[4] Wait at least one bit interval, then set
to clear bits RIE, TIE, TEIE, and MPIE,
TE and RE, to 0.
and SCMR.
rate to BRR. (Not necessary if an
external clock is used.)
the TE and RE bits in SCR to 1.
Also set the RIE, TIE, TEIE, and MPIE
bits.
Setting the TE and RE bits enable the
TxD and RxD pins to be used.