ATMEGA16U2-AUR Atmel, ATMEGA16U2-AUR Datasheet - Page 299

• Manufacturer Part Number: ATMEGA16U2-AUR
• Description: MCU AVR 8K FLASH 16MHZ 32TQFP
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA16U2-AUR

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: SPI, UART/USART, USB
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 22
• Program Memory Size: 16KB (8K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-TQFP, 32-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Data Converters: -

32. Errata
32.1
32.1.1
32.2
32.2.1
32.3
32.3.1
7799D–AVR–11/10
Errata ATmega8U2
Errata ATmega16U2
Errata ATmega32U2
rev. A and rev B
rev. A and rev B
rev. C
The revision letter in this section refers to the revision of the ATmega8U2 device.
• Full Swing oscillator
1. Full Swing oscillator
The revision letter in this section refers to the revision of the ATmega16U2 device.
• Full Swing oscillator
1. Full Swing oscillator
The revision letter in this section refers to the revision of the ATmega32U2 device.
No Known Errata
The maximum frequency for the Full Swing Crystal Oscillator is 8MHz. For Crystal frequen-
cies > 8MHz the Full Swing Crystal Oscillator is not guaranteed to operate correctly.
Problem fix/Workaround
If a Crystal with frequency > 8MHz is used, the Low Power Crystal Oscillator option should
be used instead. See table 8-1 for an overview of the Device Clocking Options. Note that the
Low Power Crystal Oscillator will not provide full rail-to-rail swing on the XTAL2 pin. If sys-
tem clock output is needed to drive other clock inputs while running from the Low Power
Crystal Oscillator, the system clock can be output on PORTC7 by programming the CKOUT
fuse.
The maximum frequency for the Full Swing Crystal Oscillator is 8MHz. For Crystal frequen-
cies > 8MHz the Full Swing Crystal Oscillator is not guaranteed to operate correctly.
Problem fix/Workaround
If a Crystal with frequency > 8MHz is used, the Low Power Crystal Oscillator option should
be used instead. See table 8-1 for an overview of the Device Clocking Options. Note that the
Low Power Crystal Oscillator will not provide full rail-to-rail swing on the XTAL2 pin. If sys-
tem clock output is needed to drive other clock inputs while running from the Low Power
Crystal Oscillator, the system clock can be output on PORTC7 by programming the CKOUT
fuse.
ATmega8U2/16U2/32U2
299