Z8F0413HH005EG Zilog, Z8F0413HH005EG Datasheet - Page 42

• Manufacturer Part Number: Z8F0413HH005EG
• Description: IC ENCORE MCU FLASH 4K 20SSOP
• Manufacturer: Zilog
• Series: Encore!® XP®r

Specifications of Z8F0413HH005EG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 5MHz
• Connectivity: IrDA, UART/USART
• Peripherals: Brown-out Detect/Reset, LED, POR, PWM, WDT
• Number Of I /o: 16
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: FLASH
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 20-SSOP
• For Use With: 770-1002 - ISP 4PORT ZILOG Z8 ENCORE! MCU269-4643 - KIT DEV Z8 ENCORE XP 28-PIN269-4630 - DEV KIT FOR Z8 ENCORE 8K/4K269-4629 - KIT DEV Z8 ENCORE XP 28-PIN269-4628 - KIT DEV Z8 ENCORE XP 8-PIN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Other names: 269-4108; Z8F0413HH005EG

HALT Mode
Peripheral-Level Power Control
Power Control Register Definitions
PS024314-0308
Executing the eZ8 CPU’s
powers down the CPU but leaves all other peripherals active. In HALT mode, the
operating characteristics are:
•
•
•
•
•
•
•
The eZ8 CPU can be brought out of HALT mode by any of the following operations:
•
•
•
•
•
To minimize current in HALT mode, all GPIO pins that are configured as inputs must be
driven to one of the supply rails (V
In addition to the STOP and HALT modes, it is possible to disable each peripheral on each
of the Z8 Encore! XP F0823 Series devices. Disabling a given peripheral minimizes its
power consumption.
The following sections describe the power control registers.
Power Control Register 0
Each bit of the following registers disables a peripheral block, either by gating its system
clock input or by removing power from the block.
Primary oscillator is enabled and continues to operate.
System clock is enabled and continues to operate.
eZ8 CPU is stopped.
Program counter stops incrementing.
Watchdog Timer’s internal RC oscillator continues to operate.
If enabled, the Watchdog Timer continues to operate.
All other on-chip peripherals continue to operate.
Interrupt
Watchdog Timer time-out (interrupt or reset)
Power-On Reset
Voltage Brownout reset
External RESET pin assertion
HALT
instruction places the device into HALT mode, which
CC
or GND).
Z8 Encore! XP
Product Specification
®
Low-Power Modes
F0823 Series
32