STEVAL-PCC010V2 STMicroelectronics, STEVAL-PCC010V2 Datasheet - Page 23

• Manufacturer Part Number: STEVAL-PCC010V2
• Description: BOARD EVAL FOR ST802RT1A
• Manufacturer: STMicroelectronics
• Series: -r

Specifications of STEVAL-PCC010V2

• Design Resources: STEVAL-PCC010V2 BOM STEVAL-PCC010V2 Schematic
• Main Purpose: Interface, Ethernet Controller (PHY and MAC)
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: ST802RT1A, STM32F207
• Primary Attributes: 1 Port, 100BASE-TX/10BASE-T
• Secondary Attributes: MII, RMII
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-11465

STM32F205xx, STM32F207xx
●
Figure 6.
1. This figure is valid both whatever the internal reset mode (ON or OFF).
In this mode, PA0 cannot be used as a GPIO pin since it allows to reset the part of the
1.2 V logic which is not reset by the NRST pin, when the internal voltage regulator in
OFF.
Regulator OFF/internal reset OFF
On WLCSP66 package, this mode activated by connecting REGOFF to V
IRROFF to V
is available only on the WLCSP package. It allows to supply externally a 1.2 V voltage
source through V
The following conditions must be respected:
–
–
–
Otherwise, PA0 should be asserted low externally during POR until V
1.8 V (see
V
between power domains (see
PA0 should be kept low to cover both conditions: until V
1.08 V, and until V
NRST should be controlled by an external reset controller to keep the device
under reset when V
DD
Startup in regulator OFF: slow V
- power-down reset risen after V
should always be higher than V
DD
. IRROFF cannot be activated in conjunction with REGOFF. This mode
Figure
CAP_1
7).
DD
and V
DD
Doc ID 15818 Rev 6
reaches 1.65 V.
is below 1.65 V (see
CAP_2
Figure
pins, in addition to V
CAP_1
6).
CAP_1
DD
slope
and V
/V
Figure
CAP_2
CAP_2
7).
DD
stabilization
.
to avoid current injection
CAP_1
and V
CAP_2
SS
DD
Description
and
reaches
reach
23/163