ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 95

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

1.2 Target ISP Port – connector pin-out
The ‘Target ISP Connector’ port features all the signals required to implement In-System
Programming (ISP) of a Target IC using the SPI, JTAG, I2C or UART interface. This connector also
features the programmable “Target Vcc” and “Target Vpp” voltages plus a switched “EXTERNAL
Vcc” supply.
The illustration below shows the location of the ‘Target ISP Connector’ port on the rear panel of the
programmer.
The pin-out of this connector is detailed in the table below.
Pin
No
1 + 2
3 + 4
5 + 6
7
8
9
ISPnano Series Programmer - User Manual – V1.11 – 12
Programmer
Pin name
TARGET_VCC
TARGET_EXT_VCC P
PROG_GND
I2C_SCL
I2C_SDA
OP6_SPARE
Programmer
Input /
Output
P
P
I/O
I/O
O
Connect to
pin on
Target System
TARGET_VCC
See notes.
Signal GROUND
(0V)
I2C SCL
I2C SDA
Spare Output
th
‘Target ISP Connector’ port
The connector is a 16-pin bump-polarised IDC
connector with 0.1” pin spacing.
Pin 1 is the top right pin as shown in the diagram
opposite.
May 2011
Notes
Target VCC
This pin should be connected to the
Target System Vcc.
Target External VCC
This pin should be connected to the
Target System Vcc.
Only use this pin if the “External
Target Vcc” is to be switched to
the “Target Vcc”
Signal Ground Connection (1)
0V to which the programmer JTAG,
SPI, I2C signal lines are referenced
to.
I2C SCL clock signal
This is the I2C SCL clock signal.
I2C SDA data signal
This is the I2C SDA data signal.
Spare Output
This is a spare output pin. It is
designed to control the activation of
the relay coils on the Relay Board.
79