ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 100

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

1.2 Target ISP Port – connector pin-out
The ‘Target ISP Connector’ port features all the signals required to implement In-System
Programming (ISP) of a Target IC using the SPI, JTAG, I2C, XMEGA PDI, ATtiny TPI or UART
interface. This connector also features the programmable “Target Vcc” and “Target Vpp” voltages
plus a switched “EXTERNAL Vcc” supply.
The illustration below shows the location of the ‘Target ISP Connector’ port on the rear panel of the
programmer.
The pin-out of this connector is detailed in the table below.
Pin
No
1 + 2
3 + 4
5 + 6
7a
7b
7c
8a
8b
8c
84
Programmer
Pin name
TARGET_VCC
TARGET_EXT_VCC P
PROG_GND
I2C_SCL
XMEGA_PDI_CLK
ATTINY_TPI_CLK
I2C_SDA
XMEGA_PDI_DATA
ATTINY_TPI_DATA
I/O
P
P
I/O
O
O
I/O
I/O
I/O
Connect to
pin on
Target System
TARGET_VCC
See notes.
Signal GROUND (0V)
ISPnano Series Programmer - User Manual – V1.11 – 12
•
•
•
•
•
•
I2C SCL
RESET
TPI_CLK
I2C SDA
TEST (PDI_DATA)
TPI_DATA
‘Target ISP Connector’ port
The connector is a 16-pin bump-polarised IDC
connector with 0.1” pin spacing.
Pin 1 is the top right pin as shown in the diagram
opposite.
Notes
Target VCC
This pin should be connected to the
Target System Vcc.
Target External VCC
This pin should be connected to the
Target System Vcc.
Only use this pin if the “External
Target Vcc” is to be switched to
the “Target Vcc”
Signal Ground Connection (1)
0V to which the programmer JTAG,
SPI, I2C signal lines are referenced
to.
•
•
•
•
•
•
I2C SCL clock signal
XMEGA CLOCK Signal
ATtiny CLOCK Signal
I2C SDA data signal
XMEGA DATA Signal
ATtiny DATA Signal
th
May 2011