ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 124

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

3.2 ‘TARGET ISP’ Port
The ‘TARGET ISP Port’ connects directly to the Target IC to be programmed on the Target System.
It is a 16-way 0.1” pitch IDC connector. It has the same pin-out as the standard ISPnano
programmers. Please see Appendix 2 for full pin-out details.
3.3 ‘Remote Control’ Port
The ‘Remote Control Port’ provides all the necessary signals for remote controlling the programmer.
It is a 16-way 0.1” pitch IDC connector. It has the same pin-out as the standard ISPnano programmer
‘Remote Control Port’. Please see Appendix 3 for full pin-out details.
3.4 ATE Port
The ‘ATE Port’ is only found on the ‘ISPnano Series 3 (ATE)’ version of the programmer.
The signals which would normally be connected from an ATE / ICT to the Target IC / Target System
(UUT) are instead connected to the ‘ATE Port’. These signals are then routed via relays under
programmer control to the ‘TARGET ISP Port’. The connector is a 14-pin IDC connector with 0.1” pin
spacing. The pin-out of this connector is detailed below.
Pin
No
1
2
3
4
108
Programmer
Pin name
Programmer I/O1
Programmer I/O2
Programmer I/O3
Programmer I/O4
I/O
I/O
I/O
I/O
I/O
Connect to
pin on
Target System
ISPnano Series Programmer - User Manual – V1.11 – 12
•
•
•
•
•
•
•
•
•
•
JTAG – TDI
SPI – MOSI
UART - TXD
JTAG – TDO
SPI – MISO
UART – RXD
PDI_RXD
JTAG – TCK
SPI - SCK
JTAG – TMS
ATE Port
The connector is a 14-pin bump-polarised IDC
connector with 0.1” pin spacing.
Pin 1 is the top right pin as shown in the diagram
opposite.
Notes
This pin can be used for JTAG, SPI
or UART Target Systems.
This pin can be used for JTAG, SPI,
UART, XMEGA PDI and ATtiny TPI
Target Systems.
This pin can be used for JTAG or
SPI Target Systems.
This pin is used for JTAG Target
Systems only.
th
May 2011