ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 37

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

19 Target JTAG
20 JTAG Programming
21 I2C Frequency
22 Target UART Speed
23 ISP Headers
24 Frequency generator
25 AVR On-chip
ISPnano Series Programmer - User Manual – V1.11 – 12
Frequency
Modes
output (SCK2)
Oscillator Calibration
The programmer supports a user-defined JTAG frequency:
The programmer supports the following JTAG modes:
The programmer supports a user-defined I2C frequency:
The programmer can support any ISP header by simply
plugging in the relevant ‘ISPnano Pin-out Converter Module’.
The currently supported ISP Headers are as follows:
Programmer can output a configurable square wave frequency
on the SCK2 pin. This is used to clock the Target Device in the
absence of a Target Oscillator.
The programmer can generate a suitable square wave for use
with ‘AVR on-chip oscillator calibration’.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
SLOW JTAG: 0 – 833 kHz
FAST JTAG: approx 1.4 MHz
Single JTAG device connected to programmer
Multiple JTAG devices connected in a JTAG Chain
JTAG ID can be verified for both Atmel AVR,
AT91SAM7 and non-Atmel JTAG devices
JTAG chain validation is also supported
SLOW I2C: 0 – 400 kHz
Supports ISP programming of both 100 kHz and 400
kHz I2C Serial EEPROMs
This is the Communications Speed (BAUD rate) from
the programmer to the Target Device when
communicating via a Boot Loader.
The BAUD rate is configurable from 1,200 to 115
kBaud.
This settings is completely independent from the BAUD
rate settings for the PC communicating with the
programmer.
Atmel 10-way (SPI)
Atmel 6-way (SPI)
Atmel 10-way (JTAG)
Atmel 20-way (JTAG) for AT91SAM7 microcontrollers
Equinox 10-way (SPI+UART)
Fast-connect wire connectors
Frequency range: 167kHz – 1.8432 MHz
th
May 2011
21