ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 36

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

11 EQTools / ISP-PRO
12 Power Supply
13 Voltage range
14 Vpp Voltage
15 DC Power Connector
16 External DC Power
18 Target SPI
20
PC requirements
Options
Generator
(2-pin JST
connector)
Connector
(2-pin JST
connector)
Frequency
PC running Windows 95 / 98 / 2000 / ME / NT4 / XP /
Windows 7
There are 2 possible modes for powering the Programmer /
Target System:
DC Power Connector for powering the programmer
External DC Power Connector for externally powering the
Target System
Software SPI algorithm:
( SPI speeds are estimations only due to uneven mark/space
ratio and non-continuous waveforms)
Hardware SPI algorithm
SLOW SPI: 115.2 kHz to 3.6864 MHz (user selectable)
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
ASCII Text Communications Mode (as standard)
ConsoleEDS (chargeable upgrade)
ISP-PRO (chargeable upgrade)
Programmer controls power to the Target System
Programmer and Target System are independently
powered
Device Programming voltage range: 1.8 – 5.0V
Programmer Controlled Power Supply range: 1.8 – 5.0V
Possible Target System voltage range: 1.8 – 5.0V
User-programmable 6.5V – 13.5V Vpp Voltage
Generator
2-pin JST connector
9.0V – 24.0V DC regulated @ 500mA (worst case)
Mates with Power Supply Adaptor supplied with
programmer
DC Power Lead fitted with 2-pin JST connector is also
supplied with programmer if a custom power supply is
to be used.
2-pin JST connector
3.0V – 24.0V DC regulated @ 500mA (worst case)
This supply can be used to switch an external power
supply to the Target System under programmer control.
SLOW SPI: 0 – 490.2 kHz (user selectable)
MEDIUM SPI: 0 – 490.2 kHz (user selectable)
FAST SPI: 115.2 kHz to 3.6864 MHz (user selectable)
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011