ISPNANO S3 KIT Equinox Technologies, ISPNANO S3 KIT Datasheet - Page 116

• Manufacturer Part Number: ISPNANO S3 KIT
• Description: ISP PORTABLE PROGRAMMER
• Manufacturer: Equinox Technologies
• Series: -r
• Type: Portable ISPr

Specifications of ISPNANO S3 KIT

• Contents: Programmer, Cables, Power Supply
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATMEL AT90S, AT90CAN, AT90USB, ATtiny, ATmega, AT91SAM7xx, Zensys Z-Wave, 24xxx Serial EEPROM's
• Other names: 483-1022; ISPNANO S3 KIT; Q5595084; T1310537

(1) TARGET
ISP PORT
(3) REMOTE
CONTROL
PORT
1.2 Rear Panel IDC Connector Ports and signal routing
The ‘ISPnano Series 3 ATE’ programmer features three ‘IDC Ports’ on the back of the programmer
as detailed in the illustration below.
The purpose of each connector is described in the table below.
(1) ‘Target ISP Port’
(2) ‘ATE ISP Port’
(3) ‘Remote Control
Port’
Instructions:
The signal routing depends on whether the relays are energised (ON) or de-energised (OFF) – see
table below.
OFF
(default)
ON
100
position
•
•
•
Relay
Connector
Connect the ‘Target System’ (UUT) to the 16-way ‘Target ISP Port’.
Connect the external ‘ATE System’ or other control system to the ‘ATE ISP Port’.
If you plan to remote control the programmer, connect the relevant remote control signals to
the ‘Remote Control Port’.
name
OFF
ON
Indicator
Relays
ON
Description
This port connects to the Target Device (UUT) on the Target
System.
This port connects to the external ‘ATE System’ or any other
control electronics which requires to be normally connected
to the Target Device on the Target System (UUT).
This port is used to remotely control the programmer from an
external ATE / ICT or PLC.
Signal routing
‘Target ISP Port’ signals are routed to the ‘ATE ISP Port’
‘Target ISP Port’ signals are routed to the ‘Internal Programmer Power
and I/O Driver Circuitry’
ISPnano Series Programmer - User Manual – V1.11 – 12
(2) ATE ISP
PORT
16-way IDC
14-way IDC
14-way IDC
Connector
th
type
May 2011