MC56F8323EVM Freescale Semiconductor, MC56F8323EVM Datasheet - Page 23

• Manufacturer Part Number: MC56F8323EVM
• Description: KIT EVALUATION FOR MC56F8323
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8323EVM

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC56F8322 and MC56F8323
• Data Bus Width: 16 bit
• Interface Type: RS-232
• For Use With/related Products: MC56F8322, MC56F8323
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Freescale Semiconductor
Preliminary
Signal Name
(prescaler_
(GPIOB4)
(GPIOB3)
(GPIOB2)
HOME0
SCLK0
MOSI0
clock)
(TA3)
Table 2-2 Signal and Package Information for the 64-Pin LQFP
Pin No.
49
25
24
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Output
Output
Output
Output
Output
Output
Output
Input/
Input/
Input/
Input/
Input/
Input/
Type
Input
State During
disabled,
pull-up is
output is
In reset,
enabled
enabled
enabled
pull-up
pull-up
Reset
56F8323 Technical Data, Rev. 17
Input,
Input,
Home — Quadrature Decoder 0, HOME input
TA3 — Timer A, Channel 3
Port B GPIO — This GPIO pin can be individually programmed as
an input or output pin.
Clock Output - can be used to monitor the internal prescaler_clock
signal (see
In the 56F8323, the default state after reset is HOME0.
In the 56F8123, the default state is not one of the functions offered
and must be reconfigured.
SPI 0 Serial Clock — In the master mode, this pin serves as an
output, clocking slaved listeners. In slave mode, this pin serves as
the data clock input. A Schmitt trigger input is used for noise
immunity.
Port B GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is SCLK0.
SPI 0 Master Out/Slave In — This serial data pin is an output from a
master device and an input to a slave device. The master device
places data on the MOSI line a half-cycle before the clock edge the
slave device uses to latch the data.
Port B GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is MOSI0.
Part 6.5.7
CLKO Select Register, SIM_CLKOSR).
Signal Description
Signal Pins
23