HS38000EPI61H Renesas Electronics America, HS38000EPI61H Datasheet - Page 206

• Manufacturer Part Number: HS38000EPI61H
• Description: DEV EMULATOR BASE UNIT H8/38000
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS38000EPI61H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: 38000 Series
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

7.8.1
Due to the use of a user system interface cable there is a slight degradation in the A/D resolution and above that
quoted in the hardware manual for the MCU being emulated.
7.8.2
The unused area from H'FF80 to H'FF8F is used by the emulator system. Therefore, if this area is allocated to the
emulator by the MAP setting, the operation is not guaranteed. Do not use this area.
Do not access the register that is not used by the MCU with the emulator.
7.8.3
When the program is executed using the Go Reset command, the E6000 emulator inputs a reset signal of
approximately 500 μs to the evaluation chip. This reset signal input time is added when the execution time
measurement result is displayed.
7.9
To remove/fasten the emulator cover and install the evaluation chip board (HS388REBK61H), take the
following steps.
1. Remove four screws from the sides of the emulator station.
2. Pull the emulator cover upward and remove it.
3. Insert connectors P1 and P2 of the evaluation chip board to the corresponding P1 and P2 of HS38000EPI61H.
4. Close the emulator cover and fasten it with the four screws.
Then fasten the two screws on the evaluation chip board to fix the board to the emulator.
1. Always switch OFF the emulator and user system before
2. Do not leave any object (such as metalic pieces) within the case
A/D Converter
Access to Unused Area
Program Execution by the Go Reset Command
Handling Evaluation Chip Board (HS388REBK61H)
connecting or disconnecting the evaluation chip board
(HS388REBK61H). Failure to do so will result in a FIRE HAZARD
and will damage the user system and the emulator product or
will result in PERSONAL INJURY. The USER PROGRAM will be
LOST.
after removing the emulator cover. Otherwise this will result in a
FIRE HAZARD and will damage the user system and the emulator
product or will result in PERSONAL INJURY. The USER PROGRAM
will be LOST.
WARNING
185