R0E00008AKCE00 Renesas Electronics America, R0E00008AKCE00 Datasheet - Page 48

• Manufacturer Part Number: R0E00008AKCE00
• Description: EMULATOR E8A FOR H8 AND M16C
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E00008AKCE00

• Contents: Emulator Board, Cables, Software and Documentation
• Core Architecture: R8C, M16C, H8
• Core Sub-architecture: R8C/Lx, M16C/60, M16C/30
• Kit Contents: E8A Emulator, USB-Interface Cable, User-Interface Cable, CD-ROM
• Features: On-Chip Debugging , Flash Memory Programming
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: 740, H8, H8S, M16C, R8C
• Lead Free Status / Rohs Status: Compliant

E8a Emulator User's Manual
Note: The emulator occupies the user’s flash memory area according to the target MCUs. For
Note: It is necessary to input the ID code of the flash memory by the target device. For details,
Note: This mode is not supported in the H8/Tiny or H8/Super Low Power series.
When the [Execute the user program after ending the debugger.] check box is selected, the user
program is executed at the same time as the debugger operation is ended with the emulator
connected to the user system. This check box is only available when the [Program Flash] mode
has been selected.
When the [Power Target from Emulator. (MAX 300mA)] check box is selected, power will be
supplied to the user system up to 300 mA. Then select 3.3 V or 5.0 V according to the power
voltage of the user system.
REJ10J1655-0400 Rev.4.00
Apr 30, 2010
⎯ Keep Flash and Connect
⎯ Program Flash
⎯ Debugging of CPU rewrite mode
This mode is used to activate the debugger while retaining data of the MCU flash memory.
However, areas for the emulator program and vector areas used by the emulator will be
changed.
This mode is used when the emulator is used as a flash memory programmer. It cannot be
used for debugging programs.
Register the load module in the workspace to download it.
This mode is used to debug the program that rewrites the CPU. In this mode, the following
debug operations, which require reprogramming of the flash memory, are not available:
- Setting the PC breakpoint
- Changing the memory contents in the flash memory area
The debugger is activated by erasing data of the MCU flash memory. A program for the
emulator program is also written to at the same time.
details, refer to the additional document, Notes on Connecting the xxxxx.
refer to the additional document, Notes on Connecting the xxxxx.
3. Preparation before Use
Page 32 of 158