R0E00008AKCE00 Renesas Electronics America, R0E00008AKCE00 Datasheet - Page 158

• Manufacturer Part Number: R0E00008AKCE00
• Description: EMULATOR E8A FOR H8 AND M16C
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E00008AKCE00

• Contents: Emulator Board, Cables, Software and Documentation
• Core Architecture: R8C, M16C, H8
• Core Sub-architecture: R8C/Lx, M16C/60, M16C/30
• Kit Contents: E8A Emulator, USB-Interface Cable, User-Interface Cable, CD-ROM
• Features: On-Chip Debugging , Flash Memory Programming
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: 740, H8, H8S, M16C, R8C
• Lead Free Status / Rohs Status: Compliant

E8a Emulator User's Manual
5. Line Assembly
6. Command Line Interface
7. Memory Save During User Program Execution
8. Load of Motorola S-type Files
9. [I/O] Window
REJ10J1655-0400 Rev.4.00
Apr 30, 2010
⎯ Variable updating
⎯ Input radix
⎯ Batch file
⎯ File specification by commands
Do not execute memory save or verifying during user program execution.
This High-performance Embedded Workshop does not support Motorola S-type files with only
the CR code (H'0D) at the end of each record. Load Motorola S-type files with the CR and LF
codes (H'0D0A) at the end of each record.
⎯ Display and modification
⎯ Note that the E8a emulator does not support the display of the invalid module in the [I/O]
For updating of the content of the variable that has been registered in the [Watch] window,
read the data after the break in user program execution. The realtime operation for the user
program is disabled because the user program is temporarily stopped.
Regardless of the Radix setting, the default for line assembly input is decimal. Specify H’
or 0x for the H8 series microcomputers and xxxxh for the R8C/Tiny, 740, M32C and
M16C series microcomputers as the radix for a hexadecimal input.
To display the message “Not currently available” while executing a batch file, enter the
sleep command. Adjust the sleep time length which differs according to the operating
environment.
The current directory may be altered by file specifications in commands. It is
recommended to use absolute paths to specify the files in a command file so that the
current directory alteration is not affected.
Do not change values in the [I/O] window because the emulator uses the address break
controller.
window. For the H8/Tiny and H8/Super Low Power series, the E8a emulator dose not
support the display of the bit information in the [I/O] window.
Example:
Example:
FILE_LOAD C:\Hew3\Tools\Renesas\DebugComp\Platform\E8a\
E8aR8C\TutorialR8C\Tutorial\Debug_R8C_E8a_SYSTEM\Tutorial.x30
Appendix D Notes on High-performance Embedded Workshop
To display “Not currently available” during memory_fill
execution:
sleep d’3000
memory_fill 0 ffff 0
Page 142 of 158