R0E00008AKCE00 Renesas Electronics America, R0E00008AKCE00 Datasheet - Page 173

• Manufacturer Part Number: R0E00008AKCE00
• Description: EMULATOR E8A FOR H8 AND M16C
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E00008AKCE00

• Contents: Emulator Board, Cables, Software and Documentation
• Core Architecture: R8C, M16C, H8
• Core Sub-architecture: R8C/Lx, M16C/60, M16C/30
• Kit Contents: E8A Emulator, USB-Interface Cable, User-Interface Cable, CD-ROM
• Features: On-Chip Debugging , Flash Memory Programming
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: 740, H8, H8S, M16C, R8C
• Lead Free Status / Rohs Status: Compliant

E8a Emulator User's Manual
Table E.1 Error Messages
Error Message
The E8a has failed.
Please connect the User interface cable
with the self-check connector in a correct
direction.
Because the User interface cable was
connected with to self-check connector,
TEST3 was interrupted.
Perform the self-check again from the
beginning.
An error occurred during USB I/O
processing.
REJ10J1655-0400 Rev.4.00
Apr 30, 2010
Description
The E8a emulator has become faulty.
If this applies to the contents guaranteed in
'IMPORTANT' described in this user's manual, we will
repair or replace your faulty product free of charge.
If this guarantee does not apply to your product's
fault, we will repair the product or replace it with a
new one with extra-charge. However, replacement
will be lower in cost and we recommend that you
purchase a new emulator.
Connect the user system interface cable to the self-
check connector in the correct direction, as shown in
figure E.2, before running the self-check program.
Execution of TEST3 was halted because the user
system interface cable was not removed from the
self-check connector before starting ‘TEST3 is
running.’
Connect the user system interface cable to the self-
check connector in the correct direction, as shown in
figure E.2, and restart the self-check program from
the beginning.
The USB cable was disconnected during execution of
the self-check program, or the E8a emulator became
faulty. Execute the self-check program again.
If this error message is displayed again, the emulator
could be faulty.
Appendix E E8aSCP (E8a Self-Check Program)
Page 157 of 158