R0E00008AKCE00 Renesas Electronics America, R0E00008AKCE00 Datasheet - Page 165

• Manufacturer Part Number: R0E00008AKCE00
• Description: EMULATOR E8A FOR H8 AND M16C
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E00008AKCE00

• Contents: Emulator Board, Cables, Software and Documentation
• Core Architecture: R8C, M16C, H8
• Core Sub-architecture: R8C/Lx, M16C/60, M16C/30
• Kit Contents: E8A Emulator, USB-Interface Cable, User-Interface Cable, CD-ROM
• Features: On-Chip Debugging , Flash Memory Programming
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: 740, H8, H8S, M16C, R8C
• Lead Free Status / Rohs Status: Compliant

E8a Emulator User's Manual
(3) Start up the host computer, and connect the E8a emulator to the USB connector of the host
REJ10J1655-0400 Rev.4.00
Apr 30, 2010
Connecting to the Self-Check Connector:
● Make sure to disconnect the USB cable from the E8a before connecting
● Fully insert the user system interface cable in the self-check connector
computer via the USB cable provided.
Figure E.2 Connecting the User System Interface Cable to the Self-Check Connector
If the E8aSCP program is executed when the USB cable remains
the user system interface cable to the user-system connector or the self-
check connector of the E8a.
connected to the E8a after ‘Disconnect’ is done from the High-
performance Embedded Workshop or Flash Development Toolkit, self-
checking will not be executed correctly. This is caused by the different
condition of the E8a pins. The E8aSCP program expects that the E8a
pins are in the condition right after starting-up the E8a, but after
‘Disconnect’ is done, they remain in the condition where the E8a is
connected to the user system.
as shown in figure E.2.
connector with the faulty-insertion-prevention nose below.
Insert the user system interface cable into the self-check
WARNING
Appendix E E8aSCP (E8a Self-Check Program)
Page 149 of 158