R0E00008AKCE00 Renesas Electronics America, R0E00008AKCE00 Datasheet - Page 26

• Manufacturer Part Number: R0E00008AKCE00
• Description: EMULATOR E8A FOR H8 AND M16C
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E00008AKCE00

• Contents: Emulator Board, Cables, Software and Documentation
• Core Architecture: R8C, M16C, H8
• Core Sub-architecture: R8C/Lx, M16C/60, M16C/30
• Kit Contents: E8A Emulator, USB-Interface Cable, User-Interface Cable, CD-ROM
• Features: On-Chip Debugging , Flash Memory Programming
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: 740, H8, H8S, M16C, R8C
• Lead Free Status / Rohs Status: Compliant

E8a Emulator User's Manual
2.3 Break Functions
The E8a emulator has the following four break functions.
(1) Hardware break function
Note: The MCUs which have no hardware break function cannot use this function.
(2) PC break function (BREAKPOINT)
(3) Forced break function
(4) Address match break function
Note: The address match break points vary depending on the device. And, user program
REJ10J1655-0400 Rev.4.00
Apr 30, 2010
Uses a break controller incorporated in the device.
The access address, instruction fetch address, data, or bus cycle condition can be set.
This function can also be set from the
refer to section 5.3.1 Address Interrupt Breakpoints.
Breaks when the dedicated instruction at the specified address that has been replaced is
executed.
This function can be set on the [Breakpoint] page in the [Eventpoint] dialog box. It can also be
set when the [S/W Breakpoints] column for the line to be set is double-clicked in the [Source]
or [Disassembly] window.
Forcibly breaks the user program.
H8 R8C series
Stops the target program immediately before a specified address instruction is executed. This
function is featured by the address match interrupt of the MCU. This function can be set from
the
Source Code.
[Event]
operation when device's address match interrupts are used is not guaranteed.
column in the
Source
window. For the setting, refer to section 5.2.2, Viewing the
[Event]
column in the
[Source]
2. E8a Emulator Functions
window. For the setting,
Page 10 of 158