101-0533 Rabbit Semiconductor, 101-0533 Datasheet - Page 12

• Manufacturer Part Number: 101-0533
• Description: KIT DEV RABBIT3000/RCM3100
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-0533

• Rohs Status: RoHS non-compliant
• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: RCM3100
• Interface Type: RS-232, Ethernet
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3.15 V to 3.45 V
• For Use With/related Products: RCM3100
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1020

2.2 Hardware Connections
2.2.1 Attach Module to Prototyping Board
Turn the RCM3100 module so that the mounting holes on the RCM3100 and on the Proto-
typing Board line up, as shown in Figure 1 below. Align the pins from headers J1 and J2 on
the bottom side of the module into header sockets RCM2JA and RCM2JB on the Prototyping
Board (these sockets were labeled J12 and J13 on earlier versions of the Prototyping Board).
Although you can install a single module into either the
on the Prototyping Board, all the Prototyping Board features (switches, LEDs, serial port
drivers, etc.) are connected to the
MASTER
Press the module’s pins firmly into the Prototyping Board header sockets—press down in
the area above the header pins using your thumbs or fingers over the connectors as shown
in Figure 1. Do not press down on the middle of the RCM3100 module to avoid flexing
the module, which could damage the module or the components on the module.
Should you need to remove the RCM3100 module, grasp it with your fingers along the sides
by the connectors and gently work the module up to pull the pins away from the sockets
where they are installed. Do not remove the module by grasping it at the top and bottom.
6
NOTE: It is important that you line up the pins on headers J1 and J2 of the RCM3100
module exactly with the corresponding pins of header sockets RCM2JA and RCM2JB
on the Prototyping Board. The header pins may become bent or damaged if the pin
alignment is offset, and the module will not work. Permanent electrical damage to the
module may also result if a misaligned module is powered up.
position.
Figure 1. Installing the RCM3100 Module on the Prototyping Board
MASTER
position — install a single module in the
MASTER
or the
RabbitCore RCM3100
SLAVE
position