EA-OEM-315 Embedded Artists, EA-OEM-315 Datasheet - Page 32
EA-OEM-315
Manufacturer Part Number
EA-OEM-315
Description
KIT LPC3141 SODIMM 66X48 200POS
Manufacturer
Embedded Artists
Type
MCUr
Datasheet
1.EA-OEM-315.pdf
(74 pages)
Specifications of EA-OEM-315
Contents
Board
For Use With/related Products
LPC3141
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
NXP Semiconductors
Table 10.
LPC3141_3143
Preliminary data sheet
Pin Name
Video related pin multiplexing
mLCD_CSB
mLCD_DB_1
mLCD_DB_0
mLCD_E_RD
mLCD_RS
mLCD_RW_WR LCD_RW_WR
mLCD_DB_2
Pin descriptions of multiplexed pins
6.28.1 Pin connections
6.28 LCD/NAND flash/SDRAM multiplexing
Default Signal Alternate Signal Description
LCD_CSB
LCD_DB_1
LCD_DB_0
LCD_E_RD
LCD_RS
LCD_DB_2
The LPC3141/3143 contains a rich set of specialized hardware interfaces, but the TFBGA
package does not contain enough pins to allow the use of all signals of all interfaces
simultaneously. Therefore a pin-multiplexing scheme is created, which allows the
selection of the right interface for the application.
Pin multiplexing is enabled between the following interfaces:
The pin interface multiplexing is subdivided into five categories: storage, video, audio,
NAND flash, and UART related pin multiplexing. Each category supports several modes,
which can be selected by programming the corresponding registers in the SysCReg.
•
•
•
•
•
•
•
•
Fast mode (400 kHz SCLwith 24 MHz APB clock; 325 kHz with12 MHz APB clock;
175 kHz with 6 MHz APB clock).
Interrupt support.
Supports DMA transfers (single).
Four modes of operation:
– Master transmitter
– Master receiver
– Slave transmitter
– Slave receiver
between the dedicated LCD interface and the external bus interface
between the NAND flash controller and the memory card interface
between UART and SPI
between I2STX_0 output and the PCM interface
EBI_NSTCS_0
EBI_NSTCS_1
EBI_CLKOUT
EBI_CKE
EBI_NDYCS
EBI_DQM_1
EBI_A_2
All information provided in this document is subject to legal disclaimers.
Rev. 0.16 — 27 May 2010
LCD_CSB — LCD chip select for external LCD controller.
EBI_NSTCS_0 — EBI static memory chip select 0.
LCD_DB_1 — LCD bidirectional data line 1.
EBI_NSTCS_1 — EBI static memory chip select 1.
LCD_DB_0 — LCD bidirectional data line 0.
EBI_CLKOUT — EBI SDRAM clock signal.
LCD_E_RD — LCD enable/read signal.
EBI_CKE — EBI SDRAM clock enable.
LCD_RS — LCD register select signal.
EBI_NDYCS — EBI SDRAM chip select.
LCD_RW_WR — LCD read write/write signal.
EBI_DQM_1 — EBI SDRAM data mask output 1.
LCD_DB_2 — LCD bidirectional data line 2.
EBI_A_2 — EBI address line 2.
LPC3141/3143
© NXP B.V. 2010. All rights reserved.
32 of 74