101-1108 Rabbit Semiconductor, 101-1108 Datasheet - Page 56

• Manufacturer Part Number: 101-1108
• Description: KIT EMBEDDED PLC APPLICATION
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: MPU Moduler

Specifications of 101-1108

• Contents: BL2500, ISaGRAF V3.50, Embedded PLC software kernel, ISaGRAF Programming Cable and Documentation
• Processor To Be Evaluated: Rabbit 3000
• Interface Type: RS-232, Ethernet
• For Use With/related Products: BL2500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 316-1120

EMBEDDED
5. On the Kernel License window, write down the
6. Once you have a valid license key, open the
7. Enter the valid license key in the License Key entry box and press Send. A confirmation message is
6.1.4 Configuring the Firmware Kernel
If you purchased an
TCP and the following TCP/IP values: IP address = 192.168.1.100, Netmask = 255.0.0.0, Default
gateway = 192.168.1.1. If you want to check or change the Target PLC configuration, follow these
instructions:
1. Open the
OEM Technology Solutions
User Reference Code (you can select the code in
the User Reference Code and copy it to the
clipboard using Ctrl-C). Contact OEM
Technology Solutions or your local distributor to
obtain a valid license key. Remember to quote
the User Reference Code. Press Cancel. An
error message dialog is displayed, press OK and
close the
License… Follow the instructions on the message dialog box in the same order: Press OK → Reset
Target. After a few seconds the License Window will be displayed and the DS2 led (red) will be
turned on.
displayed. Save the User Reference Code and License Key for future reference and technical
support. Press OK. The DS2 led (red) will be turned off and DS1 led (yellow) will start flashing every
second as an indication that the Kernel is licensed and active. For more information about the
BL2500 LED status see Section 4.6.
on the message dialog box in the same order: Press OK → Reset Target. After a few seconds the
Target Configuration Window is displayed.
Note:
Even if your Target is not active (without valid license key) you can run several samples in
the ISaGRAF Workbench in simulation mode. To run those sample files go to Section 0.
PLC BL2500 User’s Manual
EMBEDDED
EMBEDDED
EMBEDDED
PLC Utility.
PLC Utility and select Setup → Target Configuration… Follow the instructions
PLC Application Kit, the BL2500 comes pre-configured for Use Modbus
EMBEDDED
PLC Utility. Select Setup → Kernel
Loading or Upgrading the Firmware Kernel
Page 50