101-1108 Rabbit Semiconductor, 101-1108 Datasheet - Page 19

• Manufacturer Part Number: 101-1108
• Description: KIT EMBEDDED PLC APPLICATION
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: MPU Moduler

Specifications of 101-1108

• Contents: BL2500, ISaGRAF V3.50, Embedded PLC software kernel, ISaGRAF Programming Cable and Documentation
• Processor To Be Evaluated: Rabbit 3000
• Interface Type: RS-232, Ethernet
• For Use With/related Products: BL2500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 316-1120

EMBEDDED
3. Select Debug menu → Debug to open
5. A progress bar on the Debugger window will show the progress of the downloading process. Once
Troubled? If you experienced problems running this application, such as an error message “Cannot install
communication” or “Cannot start download – target not ready”, follow this checklist:
1. Make sure that the TCP/IP connection between the Target PLC and your PC is alive (use ping
2. If connection is alive, repeat accurately the step-by-step instructions in this Section. Remember to put
3. If the Target PLC has already an application running, stop it before downloading a new one.
If you still can not run this sample application, go to Chapter 7 (FAQ and Troubleshooting) which contains
more information about how to troubleshoot your particular problem.
OEM Technology Solutions
the Debugger window. The Debugger
window is displayed with a No
application message.
the downloading is completed, the application runs immediately and the SpotLight window shown
below is displayed.
command). See Section 2.4.2 on how to configure TCP/IP parameters.
correctly the Target Slave Number and the IP address of the Target PLC in the PC-PLC link
parameters window (Step 2).
Note:
If the Debugger window shows that an application is currently running (‘<application name>’
active) on the Target PLC, press Stop button
before downloading a new one. You can also stop the application from the Debugger
window menu (File menu → Stop application).
PLC BL2500 User’s Manual
4. On Debugger window, select File menu → Download.
Select “RABBIT: TIC code for Rabbit-based controllers” on
the Download window and press Download button.
If you are using RS232, on the PC-PLC link parameters
window select COM port and press Setup button. Select
the baud-rate (19200 to 600) depending on the current
value of the Target PLC.
on the toolbar to stop the application
Getting Started
Page 13