MCP215XDM Microchip Technology, MCP215XDM Datasheet - Page 76

• Manufacturer Part Number: MCP215XDM
• Description: BOARD DEMO FOR MCP215X
• Manufacturer: Microchip Technology

Specifications of MCP215XDM

• Main Purpose: Interface, IrDA
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: MCP2150, MCP2155
• Primary Attributes: IrDA Controller with PIC18F MCU
• Secondary Attributes: Set up as a Data Logger with LCD, GUI, Socket for EEPROM, Battery Powerable
• Processor To Be Evaluated: MCP2150
• Silicon Manufacturer: Microchip
• Silicon Core Number: MCP2150, MCP2155
• Kit Application Type: Interface
• Application Sub Type: Standard Protocol Stack Controller
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: MCP215XDMR; MCP215XDMR

TABLE F-1:
© 2006 Microchip Technology Inc.
Legend: S = Jumper is shorted (Closed)
Note 1:
Jumper
JP1
JP2
JP3
JP4
JP5
JP6
JP7
#
This is the jumper settings for using the integrated transceiver where the PIC16F877 controls the baud
rate and the PORTD LEDs are used.
Settings
Typical
N/A
N/A
O
S
S
S
S
JUMPER DESCRIPTIONS AND SETTINGS - REV. 1 BOARD
(1)
A description of the MCP215X/40 Data Logger Demo Board jumpers is given in
Table
F.1.2
To allow easy access to many of the system signals, a header (J4) was placed on one
of the edges of the board. This allows the signals from the MCP215X to be accessed.
FIGURE F-4:
F.1.3
The MCP2150 Data Logger Demo Board uses Firmware revision 1.00.
To connect TXIR of MCP215X to TXD of U5 (TFDS 4500)
S = TXIR connected to TXD
O = TXIR Not connected to TXD
To connect RXIR of MCP215X to RXD of U5 (TFDS 4500)
S = RXIR connected to RXD
O = RXIR Not connected to RXD
To connect EN of MCP215X to V
S = MCP215X in Low-power mode
O = MCP215X during normal operation
To connect cathode of LEDs (RD7:RD0) to V
S = Cathode of LEDs to V
O = Cathode of LEDs floating
To control source of MCP215X BAUD1 pin
To control source of MCP215X BAUD0 pin
To connect V
4500
F-1.
Signal Header
Firmware Revision
DD
to integrated optical transceiver (U5) - TFDS
J4
SIGNAL INTERFACE HEADER J14
O = Jumper is Open
Description
SS
SS
SS
The silk screen is incorrect:
CTS and RTS signals are reversed
When Open, the signal can
come from the daughter
board connected to Header
J1/J5.
When Open, the signal can
come from the daughter
board connected to Header
J1/J5.
The PCB default state is
shorted between jumper. No
jumper is required.
Comment
DS51516B-page 72