iMX233-OLINUXINO-MICRO Olimex Ltd., iMX233-OLINUXINO-MICRO Datasheet - Page 25

• Manufacturer Part Number: iMX233-OLINUXINO-MICRO
• Description: Development Boards & Kits - ARM OLINUXINO i.MX233 MICRO LINUX SBC
• Manufacturer: Olimex Ltd.

Specifications of iMX233-OLINUXINO-MICRO

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: MCIMX233CAG4C
• Core: ARM926EJ-S
• Interface Type: Ethernet, USB
• Operating Supply Voltage: 5 V
• Description/function: Single Board Linux Computer i.MX233 ARM926J at 454 MHz with UB host, TV-out (PAL / NTSC), 2x30 GPIOs, SD
• Dimensions: 76.2 mm x 43.2 mm
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 25 C
• Tradename: OLinuXino

iMX233's datasheet released by Freescale.
The pin names are also written at the bottom of the board for your convenience.
6.1.3 Classic JTAG debug
The third option is to use the classic 6-pin parallel JTAG (not including GND and VCC). There are
pads left for this option at the bottom of the board under the SD card holder. They are named
individually and framed near a “JTAG” name.
The important thing is that these pins are multiplexed with the SD card signals. In order to use the
6-pin JTAG you will have to stop using the SD card. Note also that the classic JTAG interface
comes without plastic header mounted so in order to use it you will need to use wires for
connection.
Consider the the software settings required to switch from SJTAG to 6-pin JTAG and vice verse
referring to the iMX233 manual. For instance:
The HW_DIGCTL_CTRL_USE_SERIAL_JTAG bit in the digital control block selects whether the
serial JTAG interface or the alternative six-wire parallel JTAG interface is used.
HW_DIGCTL_CTRL_USE_SERIAL_JTAG - 0x0 - Selects whether the one-wire serial JTAG
interface or the alternative six-wire parallel JTAG interface is used. 0 = Parallel six-wire JTAG is
enabled and is mapped to a collection of module pins that must be enabled by programming their
MUXSEL bits in the pin control block. 1 = Serial JTAG is enabled and uses the dedicated DEBUG
pin. The ROM bootcode writes this field prior to enabling JTAG, selecting which type of JTAG pin
signaling to use. OLD_JTAG = 0x0 Use six-wire parallel JTAG mode. SERIAL_JTAG = 0x1 Use
one-wire serial JTAG mode.
It is good idea to check the datasheet of the iMX233 processor for all the options in the digital
control block. The processor's datasheet should be always the first piece of paper you consult when
dealing with electronics.
OLIMEX© 2012
Pin # Signal Name
1 3.3VREG
2 GND
3 SJTAG_PSW
4 DEBUG
SJTAG
Processor Pin #
-
30, 35, 98, 105, 112, 118
119
84
Page 25 of 47
OLinuXino-MICRO user's manual