AK4647VN AKM [Asahi Kasei Microsystems], AK4647VN Datasheet - Page 37

• Manufacturer Part Number: AK4647VN
• Description: Stereo CODEC with MIC/HP-AMP
• Manufacturer: AKM [Asahi Kasei Microsystems]

ASAHI KASEI
When writing to the IVL7-0 and IVR7-0 bits continuouslly, the control register should be written by an interval more than
zero crossing timeout. If not, IVL and IVR are not changed since zero crossing counter is reset at every write operation. If
the same register value as the previous write operation is written to IVL and IVR, this write operation is ignored and zero
crossing counter is not reset. Therefore, IVL and IVR can be written by an interval less than zero crossing timeout.
(1) The IVL value becomes the start value if the IVL and IVR are different when the ALC starts. The wait time from
(2) Writing to IVL and IVR registers (09H and 0CH) is ignored during ALC operation. After ALC is disabled, the IVOL
MS0566-E-00
ALC bit = “1” to ALC operation start by IVL7-0 bits is at most recovery time (WTM1-0 bits) plus zerocross timeout
period (ZTM1-0 bits).
changes to the last written data by zero crossing or timeout. When ALC is enabled again, ALC bit should be set to “1”
by an interval more than zero crossing timeout period after ALC bit = “0”.
ALC bit
ALC Status
IVL7-0 bits
IVR7-0 bits
Internal IVL
Internal IVR
C6H(+20dB)
E1H(+30dB)
Figure 26. IVOL value during ALC operation
Disable
(1)
E1(+30dB) --> F1(+36dB)
E1(+30dB) --> F1(+36dB)
- 37 -
E1H(+30dB)
C6H(+20dB)
Enable
(2)
C6H(+20dB)
E1(+30dB)
Disable
[AK4647]
2006/11