ATTIny2313-16MI ATMEL Corporation, ATTIny2313-16MI Datasheet - Page 149

• Manufacturer Part Number: ATTIny2313-16MI
• Description: 8-bit AVR Microcontroller with 2K Bytes In-System Programmable Flash
• Manufacturer: ATMEL Corporation

2543C–AVR–12/03
• Bit 3..2 – USICS1..0: Clock Source Select
These bits set the clock source for the Shift Register and counter. The data output latch
ensures that the output is changed at the opposite edge of the sampling of the data
input (DI/SDA) when using external clock source (USCK/SCL). When software strobe or
Timer0 overflow clock option is selected, the output latch is transparent and therefore
the output is changed immediately. Clearing the USICS1..0 bits enables software strobe
option. When using this option, writing a one to the USICLK bit clocks both the Shift
Register and the counter. For external clock source (USICS1 = 1), the USICLK bit is no
longer used as a strobe, but selects between external clocking and software clocking by
the USITC strobe bit.
Table 62 shows the relationship between the USICS1..0 and USICLK setting and clock
source used for the Shift Register and the 4-bit counter.
Table 62. Relations between the USICS1..0 and USICLK Setting
• Bit 1 – USICLK: Clock Strobe
Writing a one to this bit location strobes the Shift Register to shift one step and the
counter to increment by one, provided that the USICS1..0 bits are set to zero and by
doing so the software clock strobe option is selected. The output will change immedi-
ately when the clock strobe is executed, i.e., in the same instruction cycle. The value
shifted into the Shift Register is sampled the previous instruction cycle. The bit will be
read as zero.
When an external clock source is selected (USICS1 = 1), the USICLK function is
changed from a clock strobe to a Clock Select Register. Setting the USICLK bit in this
case will select the USITC strobe bit as clock source for the 4-bit counter (see Table 62).
• Bit 0 – USITC: Toggle Clock Port Pin
Writing a one to this bit location toggles the USCK/SCL value either from 0 to 1, or from
1 to 0. The toggling is independent of the setting in the Data Direction Register, but if the
PORT value is to be shown on the pin the DDRE4 must be set as output (to one). This
feature allows easy clock generation when implementing master devices. The bit will be
read as zero.
When an external clock source is selected (USICS1 = 1) and the USICLK bit is set to
one, writing to the USITC strobe bit will directly clock the 4-bit counter. This allows an
early detection of when the transfer is done when operating as a master device.
USICS1
0
0
0
1
1
1
1
USICS0
0
0
1
0
1
0
1
USICLK
X
0
1
0
0
1
1
Shift Register Clock
Source
No Clock
Software clock strobe
(USICLK)
Timer/Counter0 overflow
External, positive edge
External, negative edge
External, positive edge
External, negative edge
4-bit Counter Clock
Source
No Clock
Software clock strobe
(USICLK)
Timer/Counter0 overflow
External, both edges
External, both edges
Software clock strobe
(USITC)
Software clock strobe
(USITC)
ATtiny2313/V
149