71M6534 MAXIM [Maxim Integrated Products], 71M6534 Datasheet - Page 57
![no-image](/images/no-image-200.jpg)
71M6534
Manufacturer Part Number
71M6534
Description
Exceeds IEC 62053/ANSI C12.20 Standards
Manufacturer
MAXIM [Maxim Integrated Products]
Datasheet
1.71M6534.pdf
(132 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
71M6534-IGT/F
Manufacturer:
HONEYWELL
Quantity:
10
Company:
Part Number:
71M6534-IGT/F
Manufacturer:
Maxim Integrated
Quantity:
10 000
Part Number:
71M6534-IGT/F
Manufacturer:
MAXIM/美信
Quantity:
20 000
Company:
Part Number:
71M6534-IGTR/F
Manufacturer:
Maxim Integrated
Quantity:
10 000
Company:
Part Number:
71M6534H-IGT/F
Manufacturer:
Maxim Integrated
Quantity:
10 000
Company:
Part Number:
71M6534H-IGTR/F
Manufacturer:
Maxim Integrated
Quantity:
10 000
2.3 Battery Modes
Shortly after system power (V3P3SYS) is applied, the part will be in MISSION mode. MISSION mode
means that the part is operating with system power and that the internal PLL is stable. This mode is the
normal operation mode where the part is capable of measuring energy.
When system power is not available (i.e. when V1<VBIAS), the 71M6533 and 71M6534 will be in one of
three battery modes: BROWNOUT, LCD, or SLEEP mode.
operation modes, with the possible transitions between modes. For information on the timing of mode
transitions refer to
When V1 falls below VBIAS or the part wakes up under battery power, the part will automatically enter
BROWNOUT mode (see
either LCD mode or SLEEP mode, as controlled by the MPU via the I/O RAM bits LCD_ONLY and SLEEP.
The transition from MISSION mode to BROWNOUT mode is signaled by the IE_PLLFALL interrupt flag
(SFR 0xE8[7]). The transition in the other direction is signaled by the IE_PLLRISE interrupt flag (SFR
0xE8[6]), when the PLL becomes stable.
Rev 2
Similarly, meters equipped with batteries need to contain code that transitions the chip to SLEEP
mode as soon as the battery is attached in production. Otherwise, remaining in BROWNOUT
mode would unnecessarily drain the battery.
Meters that do not require functionality in the battery modes, e.g. meters that only use the SLEEP
mode to maintain the RTC, still need to contain code that brings the chip from BROWNOUT
mode to SLEEP mode. Otherwise, the chip remains in BROWNOUT mode once the system
power is missing and consumes more current than intended.
Figure 22
Section
through
Figure 21: Operation Modes State Diagram
2.5 Wake Up
Figure
24.
Behavior). From BROWNOUT mode, the part may enter
Figure 21
shows a state diagram of the various
57