MC68HC908AS60MFN MOTOROLA [Motorola, Inc], MC68HC908AS60MFN Datasheet - Page 414

• Manufacturer Part Number: MC68HC908AS60MFN
• Description: HCMOS Microcontroller Unit
• Manufacturer: MOTOROLA [Motorola, Inc]

Analog-to-Digital Converter (ADC-15)
Technical Data
414
NOTE:
AIEN — ADC Interrupt Enable Bit
ADCO — ADC Continuous Conversion Bit
ADCH[4:0] — ADC Channel Select Bits
Recovery from the disabled state requires one conversion cycle to
stabilize.
When this bit is set, an interrupt is generated at the end of an ADC
conversion. The interrupt signal is cleared when the data register is
read or the status/control register is written. Reset clears the AIEN bit.
When set, the ADC will convert samples continuously and update the
ADR register at the end of each conversion. Only one conversion is
allowed when this bit is cleared. Reset clears the ADCO bit.
ADCH4, ADCH3, ADCH2, ADCH1, and ADCH0 form a 5-bit field
which is used to select one of 15 ADC channels. The six channels are
detailed in
analog and a digital input simultaneously to prevent switching noise
from corrupting the analog signal.
The ADC subsystem is turned off when the channel select bits are all
set to 1. This feature allows for reduced power consumption for the
MCU when the ADC is not used. Reset sets these bits.
Freescale Semiconductor, Inc.
For More Information On This Product,
1 = ADC interrupt enabled
0 = ADC interrupt disabled
1 = Continuous ADC conversion
0 = One ADC conversion
Analog-to-Digital Converter (ADC-15)
Go to: www.freescale.com
Table
23-1. Be careful when using a port pin as both an
MC68HC908AS60 — Rev. 1.0
MOTOROLA