FDC37B80X SMSC [SMSC Corporation], FDC37B80X Datasheet - Page 150

• Manufacturer Part Number: FDC37B80X
• Description: PC98/99 Compliant Enhanced Super I/O Controller with Keyboard/Mouse Wake-Up
• Manufacturer: SMSC [SMSC Corporation]

SMI Enable
Register 2
Default = 0x00
on Vcc POR
SMI Status
Register 1
Default = 0x00
on Vcc POR
SMI Status
Register 2
Default = 0x00
on Vcc POR
Default = 0x00
on VTR POR
NAME
Table 64 - Auxiliary I/O, Logical Device 8 [Logical Device Number = 0x08]
0xB5 R/W
0xB6 R/W
0xB7 R/W
0xB8 R/W
INDEX
REG
This register is used to enable the different interrupt
sources onto the group nSMI output, and the group
nSMI output onto the nSMI GPI/O pin.
Unless otherwise noted,
1=Enable
0=Disable
Bit[0] EN_MINT
Bit[1] EN_KINT
Bit[2] EN_IRINT
Bit[3] Reserved
Bit[4] EN_P12: Enable 8042 P1.2 to route internally
Bit[5] Reserved
Bit[6] EN_SMI_S: Enables nSMI Interrupt onto
Bit[7] Reserved
This register is used to read the status of the SMI
inputs.
The following bits must be cleared at their source.
Bit[0] Reserved
Bit[1] PINT (Parallel Port Interrupt)
Bit[2] U2INT (UART 2 Interrupt)
Bit[3] U1INT (UART 1 Interrupt)
Bit[4] FINT (Floppy Disk Controller Interrupt)
Bit[5] Reserved
Bit[6] Reserved
Bit[7] WDT (Watch Dog Timer)
This register is used to read the status of the SMI
inputs.
Bit[0] MINT: Mouse Interrupt. Cleared at source.
Bit[1] KINT: Keyboard Interrupt. Cleared at source.
Bit[2] IRINT: This bit is set by a transition on the IR
Bit[3] Reserved
Bit[4] P12: 8042 P1.2. Cleared at source
Bit[7:5] Reserved
Bits[7:0] Reserved
to nSMI. 0=Do not route to nSMI, 1=Enable
routing to nSMI.
pin (RDX2 or IRRX as selected in CR L5-F1-B6
i.e., after the MUX). Cleared by a read of this
register.
Serial IRQ.
150
DEFINITION
STATE
C
C
C
C