bt8375kpf Conexant Systems, Inc., bt8375kpf Datasheet - Page 219

• Manufacturer Part Number: bt8375kpf
• Description: Single Chip Transceivers For T1/e1 And Integrated Service Digital Network Isdn Primary Rate Interfaces Systems
• Manufacturer: Conexant Systems, Inc.

Bt8370/8375/8376
Fully Integrated T1/E1 Framer and Line Interface
TNEAR1
TFULL1
DL2_TS[7]
DL2_TS[6, 5]
DL2_TS[4:0]
N8370DSE
0AF— DL2 Time Slot Enable (DL2_TS)
DL2_TS[7]
7
DL2_TS[6]
Transmit FIFO Near Empty—Indicates that the data link has emptied the transmit FIFO to
below the near empty threshold specified in FEC[5:0]. After sending the byte that occupied the
near empty FIFO threshold level, TNEAR1 goes active-high, which generates a TNEAR
interrupt. The processor must write data to TDL1 to fill the transmit FIFO beyond the near
empty threshold. This is necessary to clear TNEAR1 status, and enable the next TNEAR
interrupt event.
Transmit FIFO Full—Indicates that the processor has completely filled 64 byte locations in
transmit FIFO. While TFULL1 remains active, any subsequent processor-writes to TDL1 are
ignored. If the processor inadvertently writes to TDL1 while TFULL1 is active, the processor
must allow FIFO to become completely empty without writing to TDL1_EOM. This is
necessary to force the transmitter to send an abort character.
NOTE:
Unchannelized—Test mode only, all time slots selected. Zero for normal operation.
Frame Select—Transmit and receive data link 2 operates on data only during specified T1/E1
frames. Frame select options give the processor access to different types of data link channels
and overhead channels. Overhead bit insertion is performed after TDL1, so internal transmitter
overhead insertion must be bypassed [TFRM; addr 072] before the processor-supplied
overhead can be output from TDL2.
Time Slot Word Enable—Transmit and receive data link 2 operates on data only during the
specified time slot. During T1 mode, selecting time slot 0 enables data link operation on the
F-bit positions.0B0—DL2 Bit Enable (DL2_BIT)
6
Not available in Bt8376 device.
DL2_TS[5]
DL2_TS[4:0]
5
00000
00001
11110
11111
0 = FIFO depth is below the near empty level
1 = FIFO has been emptied past the near empty level
0 = FIFO is less than full
1 = FIFO has been completely filled
00 = all frames
01 = even frames only
10 = odd frames only
11 = reserved
|
DL2_TS[4]
4
Conexant
F-bit (T1) or TS0 (E1)
Time Slot Enable
DL2_TS[3]
TS30
TS31
3
TS1
|
DL2_TS[2]
2
DL2_TS[1]
3.16 Data Link Registers
1
DL2_TS[0]
0
3-101