s5u1c17001c Epson Electronics America, Inc., s5u1c17001c Datasheet - Page 85

• Manufacturer Part Number: s5u1c17001c
• Description: Cmos 16-bit Application Specific Controller
• Manufacturer: Epson Electronics America, Inc.

3.7 Debugging Environment
The debugger supports two connect modes, of which the mode used is set by the target command.
ICD Mini mode
Simulator (SIM) mode
S5U1C17001C MANUAL
(C COMPILER PACKAGE FOR S1C17 FAMILY) (Ver. 1.1)
In this mode, the ICD Mini (S5U1C17001H) or ICD board is used to perform debugging. The program is ex-
ecuted on the target board.
Specification method
Command: (gdb) target icd usb
Specification in IDE:
To start in ICD Mini mode, make sure an ICD and target board are connected correctly, and that the power for
these units is turned on. For details on how to use the ICD, refer to the manual for the ICD used.
Note that the trace function is not available in ICD Mini mode.
In simulator mode, target program execution is simulated in internal memory of a personal computer, with no
other tools required. However, the ICD-dependent functions cannot be used in this mode.
Specification method
Command: (gdb) target sim
Specification in IDE:
The trace function is available in simulator mode. The flash writer function cannot be used.
Select "ICD Mini" from the [Debugger:] combo box in the [Create a simple startup command] dia-
log box to generate a startup command file.
Select "Simulator" from the [Debugger:] combo box in the [Create a simple startup command] dia-
log box to generate a startup command file.
Figure 3.7.1 Example of debugging system using an ICD
(included with the ICD package)
USB
USB cable
EPSON
3 SOFTWARE DEVELOPMENT PROCEDURES
Target board
ICD
4-pin to 4-pin
target system
connecting cable
(included with the ICD package)
3-63