s5u1c17001c Epson Electronics America, Inc., s5u1c17001c Datasheet - Page 254

• Manufacturer Part Number: s5u1c17001c
• Description: Cmos 16-bit Application Specific Controller
• Manufacturer: Epson Electronics America, Inc.

5 GNU17 IDE
Adding an area
Deleting an area
5-148
[Access Size:]
[Use Big Endian]
[Area Comment:]
[OK]
[Cancel]
Do the following to add a new area:
Do the following to delete an unnecessary area:
(1) From the area list of the [GNU17 Parameter Settings] page, click to select the area you want to delete.
(2) Click the [Delete] button.
(3) A dialog box for confirmation is displayed. Click [OK] to delete or [Cancel] to cancel.
(4) Click the [Apply] button to change other sections or properties or the [OK] button to end property settings.
Select the access size of the area from the following three options. This is disabled for STACK areas.
byte
halfword 16 bits
word
Select this for the area to be accessed in big endian. Unless this is selected, areas are accessed in little en-
dian. This option is disabled for STACK areas.
Enter the content of the area or other notes as a comment. You do not need to enter the symbol "#" to set off
the comments.
Closes the dialog box. The area list in the [GNU17 Parameter Settings] page is updated with the contents
you set. If any content that needs to be set remains blank, this button is disabled. Also note that after you
click [OK], the set contents are checked. If any discrepancy is detected (e.g., the set address overlaps an-
other area), an error message is displayed at the top of the dialog box, in which case the dialog box is not
closed. You must correct the erratic content of the area being edited or correct another area after temporarily
quitting by selecting [Cancel].
Discards all modifications and closes the dialog box. The area list in the [GNU17 Parameter Settings] page
is not updated.
If you haven't clicked [Apply], you can use the [Revert Settings] button to restore modified content to the
state in which this page was opened.
8 bits
32 bits
(1) Click the [Add] button.
(2) Make the necessary settings, based on the explanations given in
(3) Click the [Apply] button to change other areas or properties or the
This displays the [Add Parameter] dialog box.
"Editing an area" above. Click [OK].
[OK] button to end property settings.
If you haven't clicked [Apply], you can use the [Revert Settings]
button to restore modified content to the state in which this page
was opened.
The area added is inserted into the list in order of set address.
EPSON
(C COMPILER PACKAGE FOR S1C17 FAMILY) (Ver. 1.1)
S5U1C17001C MANUAL