agl030 Actel Corporation, agl030 Datasheet - Page 15

• Manufacturer Part Number: agl030
• Description: Igloo Low-power Flash Fpgas With Flash*freeze Technology
• Manufacturer: Actel Corporation

2 – IGLOO DC and Switching Characteristics
General Specifications
Table 2-1 •
Symbol
V
V
V
V
V
VI
T
T
Notes:
1. The device should be operated within the limits specified by the datasheet. During transitions, the input
2. For flash programming and retention, maximum limits refer to
3. VMV pins must be connected to the corresponding V
STG
J
CC
JTAG
PUMP
CCPLL
CCI
2
signal may undershoot or overshoot according to the limits shown in
recommended operating limits, refer to
and VMV
2
DC and switching characteristics for –F speed grade targets are based only on simulation.
The characteristics provided for the –F speed grade are subject to change after establishing FPGA
specifications. Some restrictions might be added and will be reflected in future revisions of this
document. The –F speed grade is only supported in the commercial temperature range.
Operating Conditions
Stresses beyond those listed in
Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
Absolute Maximum Ratings are stress ratings only; functional operation of the device at these or
any other conditions beyond those listed under the Recommended Operating Conditions specified
in
Absolute Maximum Ratings
3
Table 2-2 on page 2-2
DC core supply voltage
JTAG DC voltage
Programming voltage
Analog power supply (PLL)
DC I/O buffer supply voltage
I/O input voltage
Storage Temperature
Junction Temperature
Parameter
is not implied.
Table 2-1
Table 2-2 on page
(when I/O hot-insertion mode is disabled)
–0.3 V to 3.6 V (when I/O hot insertion mode is enabled)
–0.3 V to (V
A dv a n c e v 0. 3
may cause permanent damage to the device.
CCI
CCI
pins. See
+ 1 V) or 3.6 V, whichever voltage is lower
2-2.
Pin Descriptions
–0.3 to 1.65
–0.3 to 3.75
–0.3 to 3.75
–0.3 to 1.65
–0.3 to 3.75
–65 to +150
Limits
+125
Table 2-4 on page
Table 2-3 on page
for further information.
2-3.
2-2, and for
Units
°C
°C
V
V
V
V
V
V
2 - 1