tmp86fh46bng TOSHIBA Semiconductor CORPORATION, tmp86fh46bng Datasheet - Page 85

• Manufacturer Part Number: tmp86fh46bng
• Description: 8 Bit Microcontroller Tlcs-870/c Series
• Manufacturer: TOSHIBA Semiconductor CORPORATION

Note 3: To set the mode, source clock, PPG output control and timer F/F control, write to TC1CR during TC1S=00. Set the tim-
Note 4: Auto-capture can be used only in the timer, event counter, and window modes.
Note 5: To set the timer registers, the following relationship must be satisfied.
Note 6: Set TFF1 to “0” in the mode except PPG output mode.
Note 7: Set TC1DRB after setting TC1M to the PPG output mode.
Note 8: When the STOP mode is entered, the start control (TC1S) is cleared to “00” automatically, and the timer stops. After
Note 9: Use the auto-capture function in the operative condition of TC1. A captured value may not be fixed if it's read after
Note 10:Since the up-counter value is captured into TC1DRB by the source clock of up-counter after setting
er F/F1 control until the first timer start after setting the PPG mode.
TC1DRA > TC1DRB > 1 (PPG output mode), TC1DRA > 1 (other modes)
the STOP mode is exited, set the TC1S to use the timer counter again.
the execution of the timer stop or auto-capture disable. Read the capture value in a capture enabled condition.
TC1CR<ACAP1> to "1". Therefore, to read the captured value, wait at least one cycle of the internal source clock be-
fore reading TC1DRB for the first time.
Page 67
TMP86FH46BNG