mpc89l515ap Megawin Technology, mpc89l515ap Datasheet - Page 27

• Manufacturer Part Number: mpc89l515ap
• Description: 8-bit Micro-controller
• Manufacturer: Megawin Technology

The user can set the bit PCON.1 to drive this chip entering POWER-DOWN mode.
In the POWER-DOWN mode, the on-chip oscillator is stopped. The contents of on-chip RAM and
SFRs are maintained.
The power-down mode can be woken-up by either hardware reset or /INT0, /INT1, /INT2 and /INT3
external interrupts. When it is woken-up by RESET pin, the program will execute from the address
0x0000, and be carefully to keep RESET pin active for at least 10ms in order to get a stable clock
while waking up this chip from POWER-DOWN mode. If it is woken-up from I/O, the program will
jump to related interrupt service routine. To use I/O wake-up, interrupt-related registers have to be
programmed accurately before power-down is entered. Pay attention to add at least one “NOP”
instruction subsequent to the power-down instruction if I/O waken-up is used.
Idle
Idle
Power-Down
Power-Down
3. POWER-ON FLAG (POF)
The register bit in PCON.4 is set only by power-on action. System RESET from
watch-dog-timer, software RESET and RESET pin can not set this bit. It can be cleared by
firmware.
In System Programming (ISP)
To develop a good program for ISP function, the user has to understand the architecture of
the embedded flash.
The embedded flash consists of 30 pages. Each page contains 512 bytes.
Dealing with flash, the user must erase it in page unit before writing (programming) data
into it.
Erasing flash means setting the content of that flash as FFh. Two erase modes are available in this
chip. One is mass mode and the other is page mode. The mass mode gets more performance, but
it erases the entire flash. The page mode is something performance less, but it is flexible since it
erases flash in page unit.
Unlike RAM’s real-time operation, to erase flash or to write (program) flash often takes longer time
to finish.
MEGAWIN
Mode
Program Memory
External
External
Internal
Internal
Pin Status in IDLE Mode and POWER-DOWN Mode
MPC89x515A Data Sheet
ALE
1
1
0
0
PSEN
1
1
0
0
Port0
Float
Float
Data
Data
Port1
Data
Data
Data
Data
Address
Port2
Data
Data
Data
Port3
Data
Data
Data
Data
27