mc68hc08az60 Freescale Semiconductor, Inc, mc68hc08az60 Datasheet - Page 98

• Manufacturer Part Number: mc68hc08az60
• Description: M68hc08 Family Of 8-bit Microcontroller Units Mcus
• Manufacturer: Freescale Semiconductor, Inc

System Integration Module (SIM)
Status Flag
Protection in Break
Mode
Low-Power Modes
Wait Mode
MC68HC08AZ60 — Rev 1.0
98
The SIM controls whether status flags contained in other modules can
be cleared during break mode. The user can select whether flags are
protected from being cleared by properly initializing the break clear flag
enable bit (BCFE) in the SIM break flag control register (SBFCR).
Protecting flags in break mode ensures that set flags will not be cleared
while in break mode. This protection allows registers to be freely read
and written during break mode without losing status flag information.
Setting the BCFE bit enables the clearing mechanisms. Once cleared in
break mode, a flag remains cleared even when break mode is exited.
Status flags with a two-step clearing mechanism — for example, a read
of one register followed by the read or write of another — are protected,
even when the first step is accomplished prior to entering break mode.
Upon leaving break mode, execution of the second step will clear the
flag as normal.
Executing the WAIT or STOP instruction puts the MCU in a low power-
consumption mode for standby situations. The SIM holds the CPU in a
non-clocked state. The operation of each of these modes is described
below. Both STOP and WAIT clear the interrupt mask (I) in the condition
code register, allowing interrupts to occur.
In wait mode, the CPU clocks are inactive while one set of peripheral
clocks continue to run.
A module that is active during wait mode can wake up the CPU with an
interrupt if the interrupt is enabled. Stacking for the interrupt begins one
cycle after the WAIT instruction during which the interrupt occurred.
Refer to the wait mode subsection of each module to see if the module
is active or inactive in wait mode. Some modules can be programmed to
be active in wait mode.
Wait mode can also be exited by a reset or break. A break interrupt
during wait mode sets the SIM break stop/wait bit, SBSW, in the SIM
Freescale Semiconductor, Inc.
For More Information On This Product,
System Integration Module (SIM)
Go to: www.freescale.com
Figure 12
shows the timing for wait mode entry.
MOTOROLA
16-sim