mc68hc908mr8 Freescale Semiconductor, Inc, mc68hc908mr8 Datasheet - Page 367

• Manufacturer Part Number: mc68hc908mr8
• Description: M68hc08 Microcontrollers Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

register — A circuit that stores a group of bits.
reserved memory location — A memory location that is used only in special factory test modes.
reset — To force a device to a known condition.
ROM — Read-only memory. A type of memory that can be read but cannot be changed (written).
SCI — See serial communication interface module (SCI).
serial — Pertaining to sequential transmission over a single line.
serial communication interface module (SCI) — A module in the M68HC08 Family that
serial peripheral interface module (SPI) — A module in the M68HC08 Family that supports
set — To change a bit from logic 0 to logic 1; opposite of clear.
shift register — A chain of circuits that can retain the logic levels (logic 1 or logic 0) written to
signed — A binary number notation that accommodates both positive and negative numbers.
SIM — See system integration module (SIM).
software — Instructions and data that control the operation of a microcontroller.
software interrupt (SWI) — An instruction that causes an interrupt and its associated vector
SPI — See serial peripheral interface module (SPI).
stack — A portion of RAM reserved for storage of CPU register contents and subroutine return
stack pointer (SP) — A 16-bit register in the CPU08 containing the address of the next available
start bit — A bit that signals the beginning of an asynchronous serial transmission.
MC68HC908MR8 — Rev 4.1
Freescale Semiconductor
Writing to a reserved location has no effect. Reading a reserved location returns an
unpredictable value.
The contents of ROM must be specified before manufacturing the MCU.
supports asynchronous communication.
synchronous communication.
them and that can shift the logic levels to the right or left through adjacent circuits in the chain.
The most significant bit is used to indicate whether the number is positive or negative,
normally logic 0 for positive and logic 1 for negative. The other seven bits indicate the
magnitude of the number.
fetch.
addresses.
storage location on the stack.
Technical Data
367