mc68hc908gr8vp Freescale Semiconductor, Inc, mc68hc908gr8vp Datasheet - Page 95

• Manufacturer Part Number: mc68hc908gr8vp
• Description: M68hc08 Microcontrollers Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

9.3.7 COPD (COP Disable)
The COPD signal reflects the state of the COP disable bit (COPD) in the configuration register. See
Chapter 8 Configuration Register
9.3.8 COPRS (COP Rate Select)
The COPRS signal reflects the state of the COP rate select bit (COPRS) in the configuration register. See
Chapter 8 Configuration Register
9.4 COP Control Register
The COP control register is located at address $FFFF and overlaps the reset vector. Writing any value to
$FFFF clears the COP counter and starts a new timeout period. Reading location $FFFF returns the low
byte of the reset vector.
9.5 Interrupts
The COP does not generate CPU interrupt requests.
9.6 Monitor Mode
When monitor mode is entered with V
on the IRQ pin or the RST pin. When monitor mode is entered by having blank reset vectors and not
having V
9.7 Low-Power Modes
The WAIT and STOP instructions put the MCU in low power-consumption standby modes.
9.7.1 Wait Mode
The COP remains active during wait mode. If COP is enabled, a reset will occur at COP timeout.
9.7.2 Stop Mode
Stop mode turns off the CGMXCLK input to the COP and clears the COP prescaler. Service the COP
immediately before entering or after exiting stop mode to ensure a full COP timeout period after entering
or exiting stop mode.
Freescale Semiconductor
TST
on the IRQ pin, the COP is automatically disabled until a POR occurs.
Address: $FFFF
Reset:
Read:
Write:
Bit 7
MC68HC908GR8 • MC68HC908GR4 Data Sheet, Rev. 7
Figure 9-2. COP Control Register (COPCTL)
(CONFIG).
(CONFIG).
6
TST
on the IRQ pin, the COP is disabled as long as V
5
Low byte of reset vector
Unaffected by reset
Clear COP counter
4
3
2
1
COP Control Register
Bit 0
TST
remains
95