pca9665 NXP Semiconductors, pca9665 Datasheet - Page 83

no-image

pca9665

Manufacturer Part Number
pca9665
Description
Fm+ Parallel Bus To I2c-bus Controller
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
PCA9665
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
pca9665APW
Manufacturer:
NXP
Quantity:
12 000
Part Number:
pca9665BS,118
Manufacturer:
NXP
Quantity:
8 500
Part Number:
pca9665D
Manufacturer:
NXP
Quantity:
4 000
Part Number:
pca9665D
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
pca9665PW
Manufacturer:
NXP
Quantity:
10 142
Part Number:
pca9665PW
Manufacturer:
NXP/恩智浦
Quantity:
20 000
NXP Semiconductors
16. Handling information
17. Soldering
PCA9665_2
Product data sheet
17.2.1 Soldering by dipping or by solder wave
17.2.2 Manual soldering
17.3.1 Reflow soldering
17.1 Introduction
17.2 Through-hole mount packages
17.3 Surface mount packages
Inputs and outputs are protected against electrostatic discharge in normal handling.
However, to be completely safe you must take normal precautions appropriate to handling
integrated circuits.
There is no soldering method that is ideal for all surface mount IC packages. Wave
soldering can still be used for certain surface mount ICs, but it is not suitable for fine pitch
SMDs. In these situations reflow soldering is recommended.
Typical dwell time of the leads in the wave ranges from 3 seconds to 4 seconds at 250 C
or 265 C, depending on solder material applied, SnPb or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Key characteristics in reflow soldering are:
Lead-free versus SnPb soldering; note that a lead-free reflow process usually leads to
higher minimum peak temperatures (see
reducing the process window
Solder paste printing issues including smearing, release, and adjusting the process
window for a mix of large and small components on one board
Reflow temperature profile; this profile includes preheat, reflow (in which the board is
heated to the peak temperature) and cooling down. It is imperative that the peak
temperature is high enough for the solder to make reliable solder joints (a solder paste
characteristic). In addition, the peak temperature must be low enough that the
Rev. 02 — 7 December 2006
Figure
Fm+ parallel bus to I
49) than a PbSn process, thus
stg(max)
PCA9665
© NXP B.V. 2006. All rights reserved.
2
C-bus controller
). If the
83 of 91

Related parts for pca9665